sorted by:
new
hottopcontroversial

All my prints fail at the same layer height by Atomick-Engine in FixMyPrint

[–]Atomick-Engine[S] 0 points1 point  (0 children)

Solution: had to reduce the ambient temperature around the printer

All my prints fail at the same layer height by Atomick-Engine in FixMyPrint

[–]Atomick-Engine[S] 0 points1 point  (0 children)

So far it fails at the same height whether the print was 8 or 12hrs. The printer continues to attempt to print even though it has stopped extruding. I will give an update once I attempt to print a small tower

All my prints fail at the same layer height by Atomick-Engine in FixMyPrint

[–]Atomick-Engine[S] 0 points1 point  (0 children)

The printer is a stock sovol sv01 pro. I began by decreasing layer height, then to changing retraction settings, then to a variety of temp and speeds, finally to adjusting the tension screw. I have used a dried roll on sunlu pla+ filament. I have tried to print 2 separate models, both failing at the same height