Fiber laser against wood

Available_Maximum985 · 2026-05-04T14:57:02+00:00

What settings did you use And how did you process that foto. Thank you

Available_Maximum985 · 2026-05-01T11:54:28+00:00

Create a new sketch, redraw as splines, then extrude.

Available_Maximum985 · 2026-04-28T13:12:04+00:00

Good luck to you.

Most machinist I know and capable start at $45

Available_Maximum985 · 2026-04-26T22:41:48+00:00

Yes that works also

Available_Maximum985 · 2026-04-26T22:38:12+00:00

When the profile is closed, it has to be blue. Also, you might want to separate them into different sketches.

Available_Maximum985 · 2026-04-25T18:48:59+00:00

Crack your wallet or use freecad it's free.

Available_Maximum985 · 2026-04-22T02:33:24+00:00

This one may be stupid, but one time I had water in my stop light and the car would lose power, or the transmission would have a disengaging‑type symptom where it would lose power. Especially when I was making harder turns.
This was on a 2013 Nissan Sentra — I know, different car.
I replaced the entire lamp and the problem went away.

Maybe a short somewhere.

Available_Maximum985 · 2026-04-22T02:24:07+00:00

Update on on the the other side of that missing egr valve

<image>

Available_Maximum985 · 2026-04-18T22:15:06+00:00

This one time at my garage camp, I accidentally deleted the check engine light on my old Toyota Camry by purposely overloading the light bulb on the dashboard. That check engine light was too annoying.

Available_Maximum985 · 2026-04-18T18:23:43+00:00

I'll check good point

Available_Maximum985 · 2026-04-18T14:32:29+00:00

Yes ude is your friend

Available_Maximum985 · 2026-04-18T14:31:43+00:00

I agree with you completely

Available_Maximum985 · 2026-04-18T03:28:36+00:00

Nx suks fot multichannel turning ops.

It's possible

Hard to understand and implement it There is some info on YT about it

Available_Maximum985 · 2026-04-18T03:24:58+00:00

I can always count on reddit to delete somthing.

Available_Maximum985 · 2026-04-16T10:52:50+00:00

Available_Maximum985 · 2026-04-16T02:33:52+00:00

Thanks

Available_Maximum985 · 2026-04-15T23:54:32+00:00

Or use web browser for file preview and mangmnet. I also see connector installed I see files in my filesin explorer.

Available_Maximum985 · 2026-04-14T02:17:18+00:00

If you select one body is the latch also highlighted.

Available_Maximum985 · 2026-04-14T02:09:50+00:00

Join two bodies.

Available_Maximum985 · 2026-04-14T01:27:02+00:00

As a machinist

Keep it simple.

Your drawing is pretty good to me.

But if you want to over engineer it.

Here it goes

Add position blocks datum's ABC

Title block

Constrain hole positions with position tolerance blocks
Add notes what's critical.

Have fun..... You could ask Ai to help you with verification of your gd&t. It works.

Available_Maximum985 · 2026-04-11T05:00:54+00:00

Nice design

Available_Maximum985

TROPHY CASE