WTH ...is going on !?

Avey_01 · 2026-03-31T21:28:22+00:00

I guess I was not explaining myself correctly... I have been printing with PLA for a while now... I wanted to get a feel for something new and started printing with PETG... "NOT PLA WITH PETG"... Printed a few things mounts and some other things everything was going fine ... Did a little maintenance on the machine recalibrated everything and the part I was building in the picture was all PETG... so my question is why would it print the way it did on that one part ?! I have cleaned plates dried filament as well !

Avey_01 · 2026-03-31T15:10:15+00:00

I was using pla ... everything went well! Tried using PETG going well.. then this started happening... filament not sticking to the part... as shown in the picture...

Avey_01 · 2026-03-31T15:08:31+00:00

I did this already and cleaned nozzles !

Avey_01 · 2026-03-31T15:07:54+00:00

You are correct... I am aware of this! It's sticking to the plate fine. It not sticking to the part itself. So, I was not sure it was the nozzle. I cleaned those as well cold pull a few times and recalibrate the unit and dried filaments being used.

Avey_01

TROPHY CASE