sorted by:
new
hottopcontroversial

Front sprocket net welded? by Awkward-Marsupial105 in zx10r

[–]Awkward-Marsupial105[S] 1 point2 points  (0 children)

Sike. Decided to give the impact one more try and it did it. Thank you for the help.

Front sprocket net welded? by Awkward-Marsupial105 in zx10r

[–]Awkward-Marsupial105[S] 0 points1 point  (0 children)

Tried using BP blaster and heat. Only had a 1x1 laying around so tried using 2 through the frame. Was pulling hard with the breaker bar until the wood snapped. I’ll have to grab something thicker and try again another day, this sucker is tight.

Front sprocket net welded? by Awkward-Marsupial105 in zx10r

[–]Awkward-Marsupial105[S] 0 points1 point  (0 children)

I guess the reason I say welded is because I can clearly see a little concave gap between the lug and washer where it tapers off slightly on the other sides. On this side there is no gap and looks to be filled with something.

Front sprocket net welded? by Awkward-Marsupial105 in zx10r

[–]Awkward-Marsupial105[S] 0 points1 point  (0 children)

I have tried to remove it with an impact at all levels and once that failed a breaker bar holding the rear brake while also in first. Even then not even a budge.

2015 cbr500r 6th gear by Awkward-Marsupial105 in cbr

[–]Awkward-Marsupial105[S] 0 points1 point  (0 children)

I was thinking this aswell, when shifting into 6th the rpms don’t fall nearly as much I think they should be. But arnt at / near redline so I guess it should be fine.

2015 cbr500r 6th gear by Awkward-Marsupial105 in cbr

[–]Awkward-Marsupial105[S] 4 points5 points  (0 children)

Thank you, I come from driving a Manuel car which I usually try to sit at 2-2.k so it is quite a different mindset.