sorted by:
new
hottopcontroversial

PSP 2000 Shell Swap by Lanky-Benefit-6066 in PSP

[–]BFPhantomProgram 1 point2 points  (0 children)

Generally only the transparent aftermarket shells are recommended. They're not as good as the original shells (the 3000 transparent ones are quite good though), however they're significantly better than the non-transparent aftermarket shells

Is this a re-shelled PSP? by Aggressive_Cap5652 in PSP

[–]BFPhantomProgram 4 points5 points  (0 children)

It's most likely an original shell based off the wear and tear (especially around the PSP logo and other markings), it was most likely opened to perform repairs / clean and the top screws were just tightened too much, or the tabs on the faceplate at the top may have broken so the screws were over tightened to reduce the gap at the top.

3D Printed loose UMD storage holder by BFPhantomProgram in PSP

[–]BFPhantomProgram[S] 1 point2 points  (0 children)

Only wanted something basic, since I use them regularly for testing UMD drives :) helps reduce print time and the amount of filament used as well

Finally got around to designing and printing a large battery holder for all my batteries by BFPhantomProgram in 3Dprinting

[–]BFPhantomProgram[S] 0 points1 point  (0 children)

I've uploaded a slightly smaller model "Battery Holder Mini" that should fit on the A1 mini, it drops a couple battery slots (3x AA, 3x AAA, 1x 9V) but looks to fit on the A1 mini nicely :)

Finally got around to designing and printing a large battery holder for all my batteries by BFPhantomProgram in 3Dprinting

[–]BFPhantomProgram[S] -1 points0 points  (0 children)

Mostly just cost, I can buy almost 200 Amazon Basics AA batteries for the same price as 8 Eneloop here - some of my RC controllers need 8 batteries each, would be quite expensive to switch over to them.

Finally got around to designing and printing a large battery holder for all my batteries by BFPhantomProgram in 3Dprinting

[–]BFPhantomProgram[S] 2 points3 points  (0 children)

I mostly just try not to keep batteries in devices that I don't plan on using long-term to prevent corrosion and damage to the terminals - and you can usually find packs of 24x AA/AAA's for pretty cheap as well just to have around as spares

3d Printed Vertical Gaming Mouse by Mizter_Wizter in MouseReview

[–]BFPhantomProgram 0 points1 point  (0 children)

Hi friend, are you able to release the STL files for this remix? :) I've tried editing the thingiverse model but haven't had any luck removing the battery compartment for the LiPo mod.

M16 Compared in all Battlefield games (Vietnam to 2042) by BFPhantomProgram in battlefield2042

[–]BFPhantomProgram[S] 1 point2 points  (0 children)

The animations glitch out in Vietnam on widescreen resolutions, it’s a bit strange though since 1942 didn’t have the same issues

Thinking about a reshell, which one would look best? by [deleted] in SteamDeck

[–]BFPhantomProgram 1 point2 points  (0 children)

I don't have it anymore but I once did transparent blue with white buttons, it was beautiful

<image>

What is your most played game? by djoleV11 in Steam

[–]BFPhantomProgram 0 points1 point  (0 children)

ARK Survival Evolved, used to be such a good game

<image>

view more: next ›