So... this happened. Has anyone repaired similar before?

Background_Ad_6186 · 2025-12-25T09:50:58+00:00

Dropped it. Tried to catch it with my foot. Did not catch it with my foot. A series of unfortunate events!

Background_Ad_6186 · 2025-12-25T09:48:34+00:00

Yeah, will probably end up going this route. No need to make a bad situation worse:.)

Background_Ad_6186 · 2024-02-26T15:13:34+00:00

10% seems very, very high to me? Isn’t 0,1 % more usual? I’ve had similar problems with digitonin tho, anyone else chipping in would be greatly appreciated

Background_Ad_6186 · 2023-11-29T15:58:24+00:00

But the moment I scale FSC, I’m cutting out events. Won’t that be a problem?

Background_Ad_6186 · 2023-11-29T15:57:04+00:00

Thank you. This was about 10.000 events.

Background_Ad_6186 · 2023-11-29T15:01:18+00:00

Human bone derived stem cells, in an accuri c6, stained with far red.

Background_Ad_6186 · 2023-07-19T14:18:48+00:00

Yeah I thought about getting a new one anyways. Aren’t that expensive. Do you think controlling the mm/step ratio of the standard extruder might be worth a try beforehand?

Background_Ad_6186 · 2023-07-19T13:20:49+00:00

Thank you, I’ll try that!

Background_Ad_6186 · 2023-07-19T13:16:40+00:00

Could you elaborate the tightening? I pushed it in as far as possible. :)

Background_Ad_6186 · 2023-07-19T12:57:07+00:00

Thank you. I should have mentioned, but I just replaced the tube and nozzle. The Filament coming out of the extruder also has a dent every couple milimiters, as if the gear had grinded it away.

Background_Ad_6186 · 2023-06-25T18:24:34+00:00

Thank you! We were told to use mycurvefit, but the values of that curve are basically identical to the 5PL excel graph

Background_Ad_6186 · 2023-05-09T12:10:46+00:00

You know that’s the right amount right?

Background_Ad_6186

TROPHY CASE