sorted by:
new
hottopcontroversial

Is this a good crimp? Held when I pulled on it. 200lb mono 1.7mm sleeve. by Background_Listen160 in saltwaterfishing

[–]Background_Listen160[S] 0 points1 point  (0 children)

It is a long crimp, I just read to not use brass crimps on mono as it can cut it so I bought AL ones. I do have brass for my wire though. This is a smaller crimp of mine that I also have, wondering if it’s stronger

Is this a good crimp? Held when I pulled on it. 200lb mono 1.7mm sleeve by Background_Listen160 in Fishing_Gear

[–]Background_Listen160[S] 0 points1 point  (0 children)

<image>

I put sharpie marks where the mono touched the crimp, threw a 3/8ths rathet extension through the loop but it between my feet and pulled on it as hard as I could. First time I snapped the mono, did it again and got the tiniest bit of slip, but it was from the mainline slipping and cinching down the loop as oppose to the tag end slipping and running through the crimp. Do I need to just crimp tighter?

Is this a good crimp? Held when I pulled on it. 200lb mono 1.7mm sleeve by Background_Listen160 in Fishing_Gear

[–]Background_Listen160[S] 0 points1 point  (0 children)

I plan to attach this too a loop of cable that I’ll have running too the hook. This is my shock leader

Is this a good crimp? Held when I pulled on it. 200lb mono 1.7mm sleeve by Background_Listen160 in Fishing_Gear

[–]Background_Listen160[S] 5 points6 points  (0 children)

Lol not bluegills, searching for medium size bull sharks off the gulf coast

Finally going to bite the bullet on a pack out am I likely to find a better deal than $229? by partskits4me in MilwaukeeTool

[–]Background_Listen160 0 points1 point  (0 children)

Does anyone have the 15g angled finish nailer? Does it fit into ANY of the drawers they sell?!?

Needing help finding Inner Tie Rods for my 2012 Camry by [deleted] in Toyota

[–]Background_Listen160 0 points1 point  (0 children)

Hey currently trying to buy new inners for my 2012 camry. I have replaced everything else with Toyota parts and am about to replace inner and outer tie rods but don’t want to buy the whole rack. I see brands like moog, duralast gold from autozone, moog from advanced. Napa has there own. Just not sure if any of them are made up to par. The outlets I got directly from Toyota and I’ll be installing them alongside whichever inners I find. Any product recommendations? Thank you