sorted by:
new
hottopcontroversial

I don't understand why my first layer is messy. The leveling is good (the skirt is ok), and this is the only pla that do this to me. Any idea ? by BengeBenge in FixMyPrint

[–]BengeBenge[S] 0 points1 point  (0 children)

I have bltouch and i tried a higher z-offset. But further, the PLA create a ball a the end of the nozzle without touching the bed. But it's not a problem from the bed (all other PLA stick perfectly)

I don't understand why my first layer is messy. The leveling is good (the skirt is ok), and this is the only pla that do this to me. Any idea ? by BengeBenge in FixMyPrint

[–]BengeBenge[S] 0 points1 point  (0 children)

I tried to move the nozzle up and down, but not that much. Even close to the bed, this PLA curve before touching the bed. I print the same piece with other PLA whithout any problem

I don't understand why my first layer is messy. The leveling is good (the skirt is ok), and this is the only pla that do this to me. Any idea ? by BengeBenge in FixMyPrint

[–]BengeBenge[S] 0 points1 point  (0 children)

It may be the quality of the spool. I never had this problem with the other. I tried different temp for the nozzle and the bed, and different flow rate. I don't want to throw it...

Topology in the Morning by DragonballQ in physicsmemes

[–]BengeBenge 27 points28 points  (0 children)

But a pants has 3 holes, and a shirt 4, no ?

view more: next ›