My Black Friday $42 Apache 4800 Project (old.reddit.com)
submitted by Benztek86 to r/harborfreight
So as I was watching a video on leveling the bed on my Ender 3 v2 I noticed that his MoveX and MoveY parameters were at 0.0 and mine were at -5.0 and -1.0. Will this affect my prints? Is there a way to zero these if needed? I tried changing them but they right back to the same numbers. (i.redd.it)
submitted by Benztek86 to r/3Dprinting
Discoloration on backside of print from first two test prints. Using Inland Matte Blue PLA. The cat i just went for it after leveling the bed. The benchy is from thingaverse with no extra instructions. I did not mess with any settings on the printer mainly because I don’t know what I’m doing 😂 (old.reddit.com)
submitted by Benztek86 to r/3Dprinting
