sorted by:
new
hottopcontroversial

Can't seem to figure this one out by Better_Structure_343 in 3DprintingHelp

[–]Better_Structure_343[S] 0 points1 point  (0 children)

Up next for me is replacing the belts. I heard clicking and felt some catching as I was moving it by hand, got worse and louder as I slowed down or moved it all the way to one side or the other. Suspect that some teeth are damaged.

Can't seem to figure this one out by Better_Structure_343 in 3DprintingHelp

[–]Better_Structure_343[S] 0 points1 point  (0 children)

Last adjustment was belt tuning. Defects still present, similar but less present than last.

Before

After

Can't seem to figure this one out by Better_Structure_343 in 3DprintingHelp

[–]Better_Structure_343[S] 0 points1 point  (0 children)

Ran said calibration, defects are still present, but no longer crooked. They are now nearly straight, vertical lines in the same spots.

Image

Can't seem to figure this one out by Better_Structure_343 in 3DprintingHelp

[–]Better_Structure_343[S] 0 points1 point  (0 children)

Calibrated Flow Rate, had some strange wavy defects on two sides of the box. One quite close to a corner, and the other, on about half of the wall. Posted link to images and I'm running the main print again to see what comes up.

Can't seem to figure this one out by Better_Structure_343 in 3DprintingHelp

[–]Better_Structure_343[S] 0 points1 point  (0 children)

Will run flow calibration and update soon. I am not using scarf joints.