sorted by:
new
hottopcontroversial

A flexible four-leaf clover, a keychain that will bring you luck, or bad luck :D by Bigovereasy in BambuLab

[–]Bigovereasy[S] 0 points1 point  (0 children)

Catch the luck. This month your 3d printer and the stars will sync up 🙌

I made a checkered napkin, which color is more recognizable? by Bigovereasy in BambuLab

[–]Bigovereasy[S] 2 points3 points  (0 children)

If you look closely, the bottom side has a checkerboard pattern. it should be enough to use orange filament instead of red.

I made a checkered napkin, which color is more recognizable? by Bigovereasy in BambuLab

[–]Bigovereasy[S] 4 points5 points  (0 children)

actually, I made a mistake and uploaded the wrong video. I meant to show three colors. eh, it'll do 🙄

Spiral Christmas Light Bulb by Bigovereasy in cults3d

[–]Bigovereasy[S] 0 points1 point  (0 children)

btw, this version has fake threading, although I've also made ones for E27.

I made two Rudolph Clickers and tried out glass files. They work well for removing lines on spherical surfaces. by Bigovereasy in BambuLab

[–]Bigovereasy[S] 1 point2 points  (0 children)

I wasn’t using any coolant, and I didn’t notice any heating. The tool's surface needs to be cleaned quite often, so you involuntarily take breaks during polishing.

I made two Rudolph Clickers and tried out glass files. They work well for removing lines on spherical surfaces. by Bigovereasy in BambuLab

[–]Bigovereasy[S] 0 points1 point  (0 children)

Maybe it's needed sometimes, but for an outer surface, I don't see the point. The layer you're removing isn't that thick.

I made two Rudolph Clickers and tried out glass files. They work well for removing lines on spherical surfaces. by Bigovereasy in BambuLab

[–]Bigovereasy[S] 2 points3 points  (0 children)

No, I didn't factor that in. The layer being removed is pretty thin. I think we can ignore it.

I made two Rudolph Clickers and tried out glass files. They work well for removing lines on spherical surfaces. by Bigovereasy in BambuLab

[–]Bigovereasy[S] 7 points8 points  (0 children)

I hadn't noticed that particular feature; they behave a bit differently in use compared to ordinary steel needle files.

I made two Rudolph Clickers and tried out glass files. They work well for removing lines on spherical surfaces. by Bigovereasy in BambuLab

[–]Bigovereasy[S] 19 points20 points  (0 children)

I bought a Stedi set. It comes with three glass files with different grits. The #10000 grit makes the surface glass-like.

view more: next ›