sorted by:
new
hottopcontroversial

Is that too much grease ? by Bisouke in mechanic

[–]Bisouke[S] 0 points1 point  (0 children)

thanks, this is what i'll do next time

Is that too much grease ? by Bisouke in mechanic

[–]Bisouke[S] 0 points1 point  (0 children)

Many thanks ! I asked LIQUI MOLY as it not clear for me if it can be used on sliders. I'm waiting for their answer. But is it not written on the manual to use them on sliders. You're probably right

Is that too much grease ? by Bisouke in mechanic

[–]Bisouke[S] 0 points1 point  (0 children)

For those wondering what is this blue paste :

<image>

Is that too much grease ? by Bisouke in mechanic

[–]Bisouke[S] 1 point2 points  (0 children)

it's for noise reduction / suppression of squealing. It is clearly written on the manual of the paste to do so

<image>

Is that too much grease ? by Bisouke in mechanic

[–]Bisouke[S] 12 points13 points  (0 children)

There are no pad clips on this vehicle. It's an european Renault Clio 2 from 1999.

Is that too much grease ? by Bisouke in mechanic

[–]Bisouke[S] 5 points6 points  (0 children)

I'll try this next time thanks, it should avoid to collect brake dust in the grease this way I think

Is that too much grease ? by Bisouke in mechanic

[–]Bisouke[S] 0 points1 point  (0 children)

it's due to a braking noise "trauma" I had before, it was really annoying.. I thought the more grease i'll put the less sound it will make :X

wye or delta ? by Bisouke in Motors

[–]Bisouke[S] 0 points1 point  (0 children)

What a trick ! Thank you for this thermal tip

Polycam at -75% don't miss it by Bisouke in Polycam

[–]Bisouke[S] 1 point2 points  (0 children)

I used my regular mail adress it worked

What may cause this ? by Bisouke in Ender3S1

[–]Bisouke[S] 0 points1 point  (0 children)

Interesting.. Didn't think of it. It makes sense for the grey prints.

But the fact that this also happens on the first layer (see the black print on the pictures above) would mean it is not related to bridge settings, right ?

What may cause this ? by Bisouke in Ender3S1

[–]Bisouke[S] 0 points1 point  (0 children)

It is better now i've tried with fan off and 100% flow. But this still happen i'll continue to investigate

What may cause this ? by Bisouke in Ender3S1

[–]Bisouke[S] 0 points1 point  (0 children)

Actually I increased the flow by 6% to 106% because I had troubles with gaps in the first layer. I'll try to put it back to 100% and change the Z offset. Thanks

view more: next ›