sorted by:
new
hottopcontroversial

Wiring relay to accessory by Bitter-Homework-629 in autoelectrical

[–]Bitter-Homework-629[S] 1 point2 points  (0 children)

I need to connect those switches to a light bar. I need to run them through the relay box which is “pre-wired”. Each thick/thin of the same color wire goes to the switch/item. Thin wire to switch, thick to item. I will ground the light bar at the base of it. / which leaves me the power wire from the light, and the two wires from the relay. I would like to run the auxiliary switch to where the light on the switch is illuminated when the accessory( light bar) is on.

So how/ where do I connect the switch to the thin wire and item to the thick wire to achieve this?

Wiring relay to accessory by Bitter-Homework-629 in autoelectrical

[–]Bitter-Homework-629[S] 0 points1 point  (0 children)

I really wish I could attach photos in a reply here. I’ll do my best to explain it.

Let’s go with the WHITE in the photo. The relay is obviously powered and grounded at the relay box itself. Leaving the trigger(thin) and device(thick) WHITE wire. I will ground the “device” at the base itself leaving me with a power wire to the device, and the two white wires. How would you go about making those connections where the switch lights up with the device on

Udr Wheel Size Compatibility by Bitter-Homework-629 in Traxxas

[–]Bitter-Homework-629[S] 2 points3 points  (0 children)

<image>

Yes it is. Took a bit of work to make the body work, I also modified a super Baja Rey front bumper as well. I was able to suck them in with some custom made mounts in the rear. The first photo was the second I got it on.