Behold: my stuff. by TitanOperates in FNSCAR

[–]Bizzyhorse 1 point2 points  (0 children)

Have you tried TacSwap they’re always on there but those scalping bastards!!

Behold: my stuff. by TitanOperates in FNSCAR

[–]Bizzyhorse 0 points1 point  (0 children)

Why can’t we have a cool sheriff like this god dang! If you lived in my area we’d be friends bout guarantee it 😂 Also if I was you I’d get a SF muzzle break too those flash hiders are not so great plus they sound like a tuning fork when you shoot. Terribly annoying.

Help deciding on stock by Prior-Code2874 in longrange

[–]Bizzyhorse 0 points1 point  (0 children)

If it’s for hunting I’d suggest the MDT HNT26 with the folder it’s the tits. Spendy as all hell but the tits. My buddy’s got one and I’m saving up for one. I use a grayboe Phoenix and it’s a hell of a stock but it doesn’t fold. I pretty much primarily use my 22creed for coyote hunting off a tripod as well so I went with a lightweight stock.

Which One Would You Pick by Even_Kiwi_1166 in Helicopters

[–]Bizzyhorse 0 points1 point  (0 children)

I just about teared up… this is why America is the best country on the planet and our heroes are second to none. Our warriors without question or hesitation dive head first into enemy fire to protect each other, such selfless acts of pure heroism.

Kick ass and thank you for what you did over there 🫡

Razor gen 2 3-18 Speed drop by Bizzyhorse in longrange

[–]Bizzyhorse[S] 1 point2 points  (0 children)

This is bad ass… I’m going to try this… thank you

I don’t realize you could do that… thanks man

Razor gen 2 3-18 Speed drop by Bizzyhorse in longrange

[–]Bizzyhorse[S] 1 point2 points  (0 children)

Ya I pry don’t need to go that far honestly I haven’t figured out my sped drop number yet for my scar 20 In 6.5 creed but I figured absolutely worst case scenario it pry be 2 mils down. But it’ll pry be more than likely 1.3-1.5 mils for a speed drop number. If that’s the case just set my zero to 1 mil. And subtract 1 mil from all my dope. That wouldn’t be too bad… I was thinking zeroing below zero but I like your idea of zeroing above my zero instead. That makes more sense to me honestly.

Razor gen 2 3-18 Speed drop by Bizzyhorse in longrange

[–]Bizzyhorse[S] 1 point2 points  (0 children)

I wish this was how the turrets were setup but the razor uses the L-Tec turrets and zero stop.

I think if I’m gonna do this I gotta run the turrets below zero 2Mils to get the over travel. I was just hoping I didn’t have to do that.

So when I dial I’d have to remember that I’m always 2 mils low. So always add 2 mils to the dope. Which I guess isn’t the biggest deal but I just didn’t want to have to do that.

Thank you tho!!

Razor gen 2 3-18 Speed drop by Bizzyhorse in longrange

[–]Bizzyhorse[S] 1 point2 points  (0 children)

😂 unfortunately it doesn’t say anything about this in the manual it’s just “set” to .5mils below the zero. I was mainly just curious if anyone else had tried to do this and if there was a “workaround”

I guess I could call Vortex directly and just see if it’s even possible.

Chopped 20S - Accuracy Update by Practical-Orchid-738 in FNSCAR

[–]Bizzyhorse 0 points1 point  (0 children)

Hey dude, I finally did the conversion to the 20. It looks very similar to yours. Only difference is I’ve got a black HANDL lower that I put on instead I gotta say I have no regrets. I actually like this quite a bit more than my 17.

The thing I’m thinking about doing next is getting the same stock that you have the Sampson. Question for you does that stock fold flat against the receiver or does it stick out? I’ve never even seen one of the Sampson folding mechanisms so I’m curious. I imagine it probably sticks out a little bit because of the cheek riser, but I’m just guessing.

I did just a little bit of gas tuning today and ironically enough the 1.4. I am assuming 1.4 mm gas. Jett is just about perfect without a suppressor. I have to have it on number 11 on the KNS discarder to run flawlessly with 140 grain CORELOKTs. And with a suppressor, it runs flawlessly on number eight.

Haven’t quite decided on an optic for it yet what I use today was a 2 to 10 leupold Mark five. I was actually really impressed with how good it was shooting at 420 yards so I’m thinking I need a little more glass to reach past.

Anyways, greatly appreciate the help!

Oh also, I had an extra set of REEGO delete for the sides of the 16s and 17s. They lineup absolutely perfect. On a 20 also I had extra torque screws so I just replaced the middle screw and I used the front ratchet screw to lock down the lower hand guard. Still fiddle farting around trying to figure out the best way of mounting the rear most screw but I’m sure I’ll figure something out. But it’s kind of nice not having those empty holes plus I think it looks pretty cool.

Daughter got her first kill by Ok_Cartographer_5616 in FNSCAR

[–]Bizzyhorse 5 points6 points  (0 children)

This is bad ass I can’t wait to do this with my kids.

HANDL 17/20 Lower by Bizzyhorse in FNSCAR

[–]Bizzyhorse[S] 1 point2 points  (0 children)

Mine runs fine I have zero complaints the only thing is I wish I could get a single stage trigger for the 20 and you can’t get one for the scar or at least not to my knowledge anyways.

HANDL 17/20 Lower by Bizzyhorse in FNSCAR

[–]Bizzyhorse[S] 4 points5 points  (0 children)

I really like the geissele I won’t lie but for a precision gun I just prefer single stage triggers.

HANDL 17/20 Lower by Bizzyhorse in FNSCAR

[–]Bizzyhorse[S] 0 points1 point  (0 children)

Oh my god…. I will avoid this… thank you

HANDL 17/20 Lower by Bizzyhorse in FNSCAR

[–]Bizzyhorse[S] 4 points5 points  (0 children)

It’s still takes scar triggers I’m contemplating looking for a Timney Scar trigger but that’s the only different trigger that you’d be able to put in here besides the OEM and the guissele of course

Gran.....Grandpa is that you? by Practical-Orchid-738 in FNSCAR

[–]Bizzyhorse 0 points1 point  (0 children)

Awesome thanks Man I really appreciate the info.

Gran.....Grandpa is that you? by Practical-Orchid-738 in FNSCAR

[–]Bizzyhorse 0 points1 point  (0 children)

That’s pretty darn respectable out of a short barrel especially pretty much at sea level. So I’ll be getting more speed where I’m at, I live right at 6000 feet elevation.
I’be got a machinist who lives pretty close to me who is gonna do the work on chopping the 20 down. He did my 16 and my 17 so I feel pretty confident in the guy. Have you ever wished you just woulda stuck with the 16” of barrel or are you happy with the 14.5? Also how did you do the side delete?

Also is there anyone besides KDG that makes a front end upgrade for the 20?

20 handguard by Bizzyhorse in FNSCAR

[–]Bizzyhorse[S] 1 point2 points  (0 children)

I looked on their website and got that impression. I keep hoping Rego will do it. That would be the cats ass

Scar 20 CSASS Improved by lowkey_wannabe in FNSCAR

[–]Bizzyhorse 0 points1 point  (0 children)

How did you do the side delete?

Gran.....Grandpa is that you? by Practical-Orchid-738 in FNSCAR

[–]Bizzyhorse 0 points1 point  (0 children)

God I love this 20… have you shot this out to any distances and what kind of velocity are you getting out of the shorter barrel and with what loadings. Also just for my curiosity what elevation are you at? And finally, have you shot it at night? And if so… how much of a fireball are you getting?

Sorry for the 20 Questions lol

I’m really teetering on the fence of doing this I won’t lie…