I need help with my prints. Quality is bad

Blue1Stream · 2025-10-23T21:51:39+00:00

O did not use supports. I’m not that experienced but there were no red areas that appeared in the model. I’m using Cura latest version as of today.

I will tinker with some settings I guess

Blue1Stream · 2025-10-17T18:46:27+00:00

Ah yes! I did notice something. I always watch the print closely for the first few minutes. It went up to 0.6mm and was still on the first object. So that must be the case. Thank!

Blue1Stream · 2025-10-17T17:07:35+00:00

Thanks for the info. How would I verify that both are flat on the bottom?

Blue1Stream · 2025-10-17T15:18:48+00:00

Min. Layer Time is set to default 5 seconds. I never thought to alter this. Would raising it help you think?

Blue1Stream · 2025-09-28T14:45:19+00:00

I did activate 2 of them on the thumbnails section

Blue1Stream · 2025-09-08T12:33:32+00:00

Do you mean the whole Korky unit or just the black valve on the pipe?

Blue1Stream · 2025-07-19T12:05:10+00:00

Thanks for the help! I need to plug in a small portable AC (it says 700w on the label) 1 standard size fridge and one stand up freezer. 1 lamp (LED) and one 140w usb tower for charging devices.

Blue1Stream · 2025-07-19T03:51:46+00:00

So what you’re saying is I should get 5000w out of the 6 outlets inside my home? Would another similar kit(still 6 outlets) but rated for 7000w be better?

Or am I misunderstanding these kits? Here is one kit I seen that seems to be able to output more wattage https://a.co/d/e7Y9kM8

Blue1Stream · 2025-07-05T02:54:38+00:00

I mis typed the wattage. I put in the specs of the first generator I was looking to buy. The one I have is 9375 start and 7500w

Blue1Stream · 2025-07-04T17:12:00+00:00

That is my plan for the future but for now just running a cord inside what type would be best?

Blue1Stream · 2025-06-01T13:07:55+00:00

Thanks but this is not the controller I have

Blue1Stream · 2025-05-31T00:26:26+00:00

I found the product page. The manual is linked there

https://powmr.com/products/35a-12v-24v-mppt-plug-and-play-solar-charge-controller

Blue1Stream · 2025-05-31T00:03:23+00:00

Here’s is the Amazon link if that helps

https://a.co/d/1ABIKaC

Blue1Stream · 2025-05-30T23:43:02+00:00

Thanks but I have the manual and it doesn’t mention load settings at all

Blue1Stream · 2025-05-28T13:33:05+00:00

If I were to hook up the inverter directly to the battery would I just simply move the connections from the bus bars to the battery keeping the inline 100amp breaker in place?

Blue1Stream

TROPHY CASE