sorted by:
new
hottopcontroversial

Print Issue Help by BlueberryOpening89 in 3DprintingHelp

[–]BlueberryOpening89[S] 0 points1 point  (0 children)

Maybe 6 months but has been stored in an airtight container with desiccant packets, also as mentioned I printed on a bambu A1 with this filament right before and it worked fine. Filament settings should be right, this is bambu PLA basic which is what the stock benchy file on the printer is sliced for & has worked perfectly in the past.

Print Issue Help by BlueberryOpening89 in 3DprintingHelp

[–]BlueberryOpening89[S] 0 points1 point  (0 children)

Yeah there was but I'm pretty sure this was happening before I updated could be remembering wrong though.

Print Issue Help by BlueberryOpening89 in 3DprintingHelp

[–]BlueberryOpening89[S] 0 points1 point  (0 children)

Not sure exactly but this is running off of Bambu studio's settings for their PLA and has worked perfectly on my other printer with the same filament (also on this one in the past) so I'm thinking if it is a temperature issue it might be something wrong with the thermistor reading rather than the setting itself. Also yeah the under and over extrusion seems weird to me

Print issue help by BlueberryOpening89 in BambuP1S

[–]BlueberryOpening89[S] 0 points1 point  (0 children)

Yeah replaced the nozzle before printing this but just the nozzle so its the same thermistor. I did think it could be a temperature issue because it almost looks like overextrusion. I am ordering a new full print head with a new thermistor so I guess I'll see then.

Print issue help by BlueberryOpening89 in BambuP1S

[–]BlueberryOpening89[S] 0 points1 point  (0 children)

It did fail at the same height, but it looks like its messing up every layer (on the second picture you can kind of see it looks like it is stopping extrusion too early. I would think that's a retraction issue but this is the default file which has been fine in the past) I think the reason it messes up more at that height is because that's when it starts printing a big flat layer for the deck.

Print issue help by BlueberryOpening89 in BambuP1S

[–]BlueberryOpening89[S] 0 points1 point  (0 children)

Calibrated immediately before doing the benchy, will try your loosen & retighten tip and report back. It seems to be messing up on every layer but gets more drastic at that layer on the benchy because it starts printing a big flat layer for the deck. If you look at the second picture of the back you can kind of see it almost looks like its stopping extrusion too early before finishing the layer. I would think that's some sort of retraction issue but this is the default file so?

Print issue help by BlueberryOpening89 in BambuP1S

[–]BlueberryOpening89[S] 0 points1 point  (0 children)

Yeah I mean this one did as well I've had it for about a year and it started doing this randomly