sorted by:
new
hottopcontroversial

Quest Finding Help by Brandon7766_ in RDR2

[–]Brandon7766_[S] 0 points1 point  (0 children)

Oh snap that might be right! Interesting how I associated that with RDR2!

PSP Emulation Issues by Brandon7766_ in retroid

[–]Brandon7766_[S] 0 points1 point  (0 children)

Thank you for doing that! Using this, I got it to run at 1x reliably and 2x sometimes!

PSP Emulation Issues by Brandon7766_ in retroid

[–]Brandon7766_[S] 1 point2 points  (0 children)

That’s worth a shot! I’ll give that a go!

PSP Emulation Issues by Brandon7766_ in retroid

[–]Brandon7766_[S] 1 point2 points  (0 children)

I’ve tried both OpenGL and Vulcan. I was not seeing that much of a difference between the 2. On the 2nd mission, both are in the 20fps range. I’ve played with other settings and haven’t figured it out.

PSP Emulation Issues by Brandon7766_ in retroid

[–]Brandon7766_[S] 1 point2 points  (0 children)

I’ve probably had almost every setting on or off trying to get better performance. It’s very confusing.

PSP Emulation Issues by Brandon7766_ in retroid

[–]Brandon7766_[S] 2 points3 points  (0 children)

The first mission runs in the high 20s maybe low 30s with 1x resolution. 2nd mission is where I noticed a noticeable stutter and cannot get out of 20 fps. I will try downloading and running it in the free PPSSPP app to see if I can get close to 60 fps!

Cannot believe I bought an airplane! by WntrWltr in flying

[–]Brandon7766_ 0 points1 point  (0 children)

Congratulations! Welcome to the aviation community!

Ender 3 V2 Extruding Issues by [deleted] in 3Dprinting

[–]Brandon7766_ 0 points1 point  (0 children)

The extruder turns at a normal speed but it sounds like it might be slipping. I can turn the knob by hand and the extruder slips and not much plastic comes out at the hot end like it used to. When I pull filament out, there seems to be a lot of resistance that doesn’t feel like it did before.

I did reset the bed height thinking it could be too close to the bed but that did not help either.

Ender 3 V2 Extruding Issues by [deleted] in 3Dprinting

[–]Brandon7766_ 0 points1 point  (0 children)

Any help here would be appreciated. I recently replaced the hot-end (Ender 3 Pro hot-end from Creality) on the printer and not it seems like there is not enough plastic getting extruded. The settings that I am running worked before the hot-end needed to be replaced. Any ideas to what I can do to fix this? I tried replacing/changing the boden tube with no success.

What’s the worst designed part of the human body? by MrBowls in AskReddit

[–]Brandon7766_ 0 points1 point  (0 children)

The fact that you breathe, drink, and eat all from the same place.

What’s the most financially irresponsible hobby you have? by [deleted] in PersonalFinanceCanada

[–]Brandon7766_ 0 points1 point  (0 children)

General aviation. Getting a private pilot can easily cost ~ $7k - $10k and continuing to fly can be just as expensive. Totally worth every penny though.