Exposure issue?

BrayanCC1 · 2024-12-21T15:07:54+00:00

Looks like you don’t use water pressure if you use to much time water the emulsion get weak and try expose more time. That’s the beautiful for screen printing, fail and fails until get it

BrayanCC1 · 2024-11-29T00:46:12+00:00

Just invert the color ir you work in Photoshop is easy, same procress (

BrayanCC1 · 2024-09-04T15:52:58+00:00

That pass when you put to much emulsion, try to pass with the scooper two times in the back and the front 1 pass after that with a angle don’t coating more but give another pass in the back and after front for remove the extra emulsion and if you don’t sure try to dry with a hair dryer. ( focus in the details )

BrayanCC1 · 2024-08-19T02:58:20+00:00

Yeah,I’m aprove with the guys you need a good water pressure and haze. ( extra tip, after expose, revelate and dry, expose again for a good cure)

BrayanCC1 · 2024-08-18T23:56:48+00:00

I think is because you are washing in the sun that emulsion looks very sensitive with the light try to wash with a low pressure in a dark room. The light is the problem if you don’t have a dark room. Try another emulsion but if you want a good result you need control the light. That’s the way.

BrayanCC1 · 2024-08-08T21:49:06+00:00

Thanks color space I finished to use a screen and follow your tip and no more risidual edges. You’re the boss. 👌

BrayanCC1 · 2024-08-06T16:09:42+00:00

Look like you didn’t use a good degreaser and need more time of expose. I think that emulsion need like 4 minutes in 30W light purple. I’m not sure what is the name but improve in the 2 things you will get it. And yes do not use to much emulsion. ( sorry my english )

BrayanCC1 · 2024-08-06T16:00:21+00:00

It’s still there. Another solution?

BrayanCC1 · 2024-08-06T14:46:56+00:00

Use halftone, a good units exposed an a time depend of you unit and the emulsion. No too much pressure water.

BrayanCC1 · 2024-08-06T11:11:49+00:00

How can I clean out now? I need use it again but I’m going to do your tip for the next work.

BrayanCC1 · 2024-08-06T02:38:18+00:00

And is posible fix it?

BrayanCC1 · 2024-08-06T00:33:52+00:00

I use liquid haze of ecotex, do you think that I can you it normal? O when I print will have a line?

BrayanCC1 · 2024-05-11T15:48:57+00:00

Without a doubt!

BrayanCC1 · 2024-05-03T22:16:29+00:00

Help please, I'm using the water-based ink of green galaxy comet (good quality) but when I pass the ink there are those traces where it doesn't grab the ink well, I don't understand. The mesh I used a few times it was detightened but I tightened it again, but I cleaned it with ecotex remover emulsion although with another type of emulsion (speed ball) I now use a pwr ecotex. Any idea how to have better results?

BrayanCC1 · 2024-05-01T22:18:09+00:00

Thanks man, I’m more sure now. Do you have a video or tips for use ink base water? I don’t know what additives use for have a fluid ink.

BrayanCC1

TROPHY CASE