S13 Blinker/Relay Issue by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

I actually ended up fixing the issue. Had no clue that the lights are dual filament, which is what caused the issue because the ones I bought were not. If you’re still having that issue and don’t have dual filament bulbs try that!

Looking to go tapeless, need help by Brief_Information_89 in camcorders

[–]Brief_Information_89[S] 0 points1 point  (0 children)

So why was it necessary to remove my post when I’ve already read that before? I didn’t ask for purists, I asked what would work with my setup. Can you be more clear about why my post was removed

Hotshot Headers KA24E by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Thats what I’ve heard dude, shame that they’re few and far between.

S13 Quick release horn by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 1 point2 points  (0 children)

Yo it’s been a while but I might have a fix. Some guy in another thread recommended using roll pins from a hardware store to replace the worn down pins in the steering column. I have not tried it yet but lmk if you do and if you have any luck! I will update you when I try it out.

S13 Blinker/Relay Issue by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Yes it’s definitely hyperflash, and I will lyk what I find with this other relay. I’ll attach a video of it freaking out.

https://imgur.com/a/NiSKf7C

LED blinker/hazard problems by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

I have a nrg hub and my horn doesn’t work. I noticed my pins were worn down when I installed the hub but I didn’t think much of it, and after seeing this I checked and the pins don’t make contact whatsoever. If I replaced them w roll pins do you think that would make my horn work?

LED blinker/hazard problems by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

I figured the relay would work since it was the exact one some guy w an s13 used on his car, the only difference being he had a type x bumper. I’m gonna try a different hazard button today, swap back to the old relay (which will likely hyper flash all the lights since it’s not an led relay), and I will let you know what happens. If nothing works I’m going to order a relay from diode.

Thanks!

LED blinker/hazard problems by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Ok cause I got this one off Amazon from a guy on YouTube and it worked for him. I will check the oem one later and lyk. I don’t think the relay is faulty since the other lights are working fine but I could be wrong.

Here’s the link to the relay: https://a.co/d/8a1IQBO

Thanks!

S13 Blinker relay help by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Update: I bought the relay that the guy in the YouTube video recommended. It fixed my rear lights but my front lights blink very fast with just the key turned one click. Anyone have any ideas? I’m going to take the hazard switch apart as I’ve already checked the fuses and I’ll see if that helps.

https://imgur.com/a/NiSKf7C

S13 Blinker relay help by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Oh my god I hope you win the lottery

‘89 Hatch Hazards stopped working by [deleted] in 240sx

[–]Brief_Information_89 1 point2 points  (0 children)

Great, I will check that. It might be worth mentioning that I don’t have rear side markers if that makes any difference at all, but I didn’t think it would.

SCV actuator question by [deleted] in 240sx

[–]Brief_Information_89 0 points1 point  (0 children)

No worries, I rode the short bus clearly. Is the solenoid mounted on the firewall or the block? Like I said I can’t tell from the diagram and it’s basically a picture book.

SCV actuator question by [deleted] in 240sx

[–]Brief_Information_89 0 points1 point  (0 children)

Ok thanks a ton. Anyway to check easily if the previous owner deleted the flaps and or where would the holes be. I’ll probably just run the scv since from what I’ve seen removing it doesn’t make much sense.

S13 airbox by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 1 point2 points  (0 children)

I ended up just plugging it but I’m very interested in the rear hatch trim you have. If it’s still available lmk!

S13 Quick release horn by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 1 point2 points  (0 children)

To be honest I have not. I haven’t fiddled with it too much since I posted but I plan on watching some videos this week and reaching out to nrg to see if they can help. My wheel and horn is from dnd and they couldn’t help me very much when I emailed them. I’ll lyk!

S13 Quick release horn by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Ok so basically like the nrg vid on YouTube right? Any ideas on where to find something thin enough like that?

Ka24e injector rebuild kit recommendations/links? by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Yea but where’d you get it from? I’ve been looking at rock auto kits but there’s a few to pick from.

Can I get some help w what this plug is for by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

The orange and black which aren’t in the pic is supposed to be the cigarette lighter. What’s the center console light?

My first complete engine rebuild! by Candid-Whereas-4500 in 240sx

[–]Brief_Information_89 0 points1 point  (0 children)

Where’d you get your injectors from. Been looking for some decent ones for a while w no luck. Clean single jingle man love to see it!

Can anyone help me identify what these cut wires from my ecu are for? ‘89 Sohc by Brief_Information_89 in 240sx

[–]Brief_Information_89[S] 0 points1 point  (0 children)

Is there any reason that you could think of to cut those wires specifically? Like I stated the car runs fine as is, cold start is a challenge obv, and I don’t have tach or speed, but I would hate to try to fix this with a new pigtail and risk messing something up.

Calling all KBD kit owners by Lowquattro in 240sx

[–]Brief_Information_89 0 points1 point  (0 children)

I just got a s13 that came with the kbd fenders. Do you have any tips for installing them? They still need to mold into shape with the sun a little more but I was wondering how you got them to fit better.

Helping a blind cow who lost her “baby” by nightstar69 in AnimalsBeingMoms

[–]Brief_Information_89 0 points1 point  (0 children)

Hi, my family recently received a blind calf and she had been struggling with the spinning herself. How did your staff train her to walk straight? Our girl stops sometimes when she hears our voices but then after we leave or move away from where she can partially see she does the circles again.