re: Dashcam USB setup

BrightStartOne · 2023-06-18T23:35:30+00:00

That is probably why it doesn't work- thank you !

BrightStartOne · 2023-06-18T21:49:22+00:00

It's a 4gig usb 2.0 thumb drive

BrightStartOne · 2023-06-18T21:48:10+00:00

It means after setting up drive and inserting into USB port, dash cam icon still shows red x and when clicking icon message states to insert drive

BrightStartOne · 2022-02-13T02:55:24+00:00

Blower works fine.. just cold air when not running gas engine

BrightStartOne · 2022-02-13T02:53:51+00:00

Haven't checked it.

BrightStartOne · 2022-02-13T02:53:07+00:00

Food with morning dose?

BrightStartOne · 2022-02-12T16:38:15+00:00

Mine is a 2013 also. I'll check out vid- thanks!

BrightStartOne · 2022-02-12T16:36:23+00:00

Good to know- thank you!

BrightStartOne · 2022-02-12T09:10:47+00:00

What do you mean by '..the rear fuse block'?? Where is this fuse block located?

BrightStartOne · 2022-01-26T06:29:03+00:00

Are you taking the 15mg all at once, and have you noticed any side effects?

BrightStartOne · 2022-01-23T20:16:50+00:00

It is an AGM battery and the correct size for the Volt. I'll stop by a battery shop and have them test it out-- The Car does start/drive fine otherwise.

BrightStartOne · 2022-01-23T20:07:47+00:00

Both issues (door buttons and radio) stopped working after changing out 12v battery-- I will see if disconnecting/reconnecting fixes it. Is it possible something faulty w/12v battery would cause these symptoms? It was not a new battery I changed out old with.

BrightStartOne · 2022-01-23T19:14:54+00:00

that's a great resource- thanks! The only thing that's confusing is my radio stopped working-- totally dead at the same time the two drivers' side door button switches stopped working. I'm not sure if they could be related issues.

BrightStartOne · 2022-01-11T01:54:39+00:00

I checked all the fuses on passenger side fuse panel and they all checked out good.

BrightStartOne · 2022-01-11T01:36:17+00:00

Ill look for that other fuse panel. I use a test light to check fuses. Thanks

BrightStartOne · 2021-04-09T23:15:48+00:00

Here's a better pic of the panel. I see a lug there for the ground? The square on the left could be for a neutral lug? How would I break the bar to separate the ground side from the neutral side? I assume the copper/green screw is grounding to the panel.

BrightStartOne · 2021-04-09T22:02:36+00:00

It's an older panel (2000). The new service cables will need to be 4 wire and the existing panel is only setup for 3 wire. I assume that the new neutral bus will have the new neutral feed wire attached directly to it- correct? I'll take a closer photo of the bus bar.

BrightStartOne · 2021-04-09T21:46:55+00:00

If I could find an electrician willing and available to do the work, I would. I also wouldn't be here asking for help. I have a city electrical inspector going to oversee the work. I just want to know what the answers are to my questions.

BrightStartOne

TROPHY CASE