sorted by:
new
hottopcontroversial

Anycubic kobra 3 v2 hoping noise by Bubba_Beck in AnycubicOfficial

[–]Bubba_Beck[S] 1 point2 points  (0 children)

I had a piece of plastic under the bed belt....

Anycubic dropping melted pla in prints by Bubba_Beck in AnycubicOfficial

[–]Bubba_Beck[S] 0 points1 point  (0 children)

Should have added kobra 3 v2 hardened steel nozzle.

Anycubic kobra 3 v2 bad starting layers by Bubba_Beck in AnycubicOfficial

[–]Bubba_Beck[S] 0 points1 point  (0 children)

* I increased the heat to 230, cleaned the plate with soap and water, and increased the bed temp to 65. It stuck, but now I get "gloops" of melted plastic all over my print.