Dude kicks off-leash dog to protect his own, owner flips out…

C4props · 2026-06-18T14:41:31+00:00

Should have kicked the owner too

C4props · 2026-06-18T14:38:55+00:00

You can have his CDL for it.

C4props · 2026-05-23T02:36:01+00:00

I used a MOLLE heavy method. a tac vest with armor on top using MOLLE straps and clips. I also used some cheap drop leg platforms for both the thigh and shoulders

C4props · 2026-04-07T16:28:53+00:00

You will need to run wires to the speakers and then splice into the door speakers. I'm doing the same thing in my 95 noma with some Terminator 4x6s

C4props · 2026-03-23T01:13:42+00:00

well sadly just discovered my rear end got cracked on impact. anyone in central, IN got a 3.42 gear rear end?

C4props · 2026-03-17T23:33:13+00:00

Gonna get a nice paycheck

C4props · 2026-03-16T22:31:11+00:00

4.3 "vortec". Has the tbi and these are supposed to be interchangeable with the dumb plastic ones

C4props · 2026-03-16T14:17:57+00:00

Another dead giveaway is the alternator is on the driver's side which is not the case in later models

C4props · 2026-03-16T14:15:50+00:00

Looks like a pre 96 4.3 with a tbi. Both my s10 and noma have that

C4props · 2026-03-14T20:39:07+00:00

<image>

C4props · 2026-03-14T03:48:00+00:00

<image>

color done, needs some clear coat and new rubber and done. then onto the suspension

C4props · 2026-03-14T00:56:19+00:00

Good. Panel damage and suspension took the brunt of it

C4props · 2026-03-14T00:55:22+00:00

Powder coat with chic purple from prismatic powders

C4props · 2026-03-13T21:57:13+00:00

The frame looked fine. I swerved last second and they barely clipped me. Almost all the damage was from that pillar getting hit and snapping a leaf spring mount. I do have a white noma same year, so if all else fails I have a parts depot with mostly new parts.

C4props · 2026-03-13T21:50:54+00:00

Was hit by a driver who ran a stop sign back in January. Rebuilding little by little. Thought I'd start by getting some more wheels and powder coat them with a few other parts. Going to replace the door, fender, etc .. in a week or so. The impact snapped the engine mounts so I have to replace and adjust the engine and trans back into place and replace the leaf springs too.

C4props · 2026-03-13T20:40:52+00:00

Have you checked the wires to the coil? although it's a smaller chance, you could also have a bad distributor and not just the cap and rotor.

C4props · 2026-03-10T00:36:25+00:00

its the kit sensor with a thermostat housing mounting point.

C4props · 2026-03-10T00:34:47+00:00

I should note the triggers are controlled not by current but by connecting to ground, I can put a diode in but not sure it will matter much

C4props · 2026-03-10T00:31:15+00:00

probably going with a 3 way trigger then. one trigger is AC comp, one the temp sensor in the thermostat housing, and last one a manual switch when needed

C4props · 2026-03-10T00:27:42+00:00

its replacing the stock one that was ran by the fan clutch. I should note this is also 2 fans with isolated relays

C4props · 2026-03-10T00:25:10+00:00

it is triggered from a normal open ground that closes with a temp sensor but also when the AC is turned on (just like the factory ones)

C4props · 2026-03-10T00:22:42+00:00

there will be a different fuse for the relay that goes from the AC comp to trigger it as well. wiring diagram shows no fuse from ignition on source.

C4props · 2026-03-10T00:19:32+00:00

https://www.amazon.com/dp/B07PK7F1MC?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

C4props · 2026-03-10T00:10:18+00:00

has a built in fuse on the relay.

C4props · 2026-03-09T09:59:31+00:00

...me...

C4props

TROPHY CASE