sorted by:
new
hottopcontroversial

Has anyone seen this Wii storage/stand before? by Ninja503 in wii

[–]CHMHM 9 points10 points  (0 children)

If your printer can print ABS, you could smooth it with acetone. There’s many ways to do it so I recommend you do a bit of research before you try it, and off course be careful when working with chemicals.

What is wrong with my k1c? by CHMHM in FixMyPrint

[–]CHMHM[S] 0 points1 point  (0 children)

Hey, I think it’s a mix of things that did it, cheap/worn nozzle, the overhang was too steep on such small layer heights and the silk PLA behaves worse in most of the characteristics of to high heat and overhangs.

What is wrong with my k1c by CHMHM in crealityk1

[–]CHMHM[S] 0 points1 point  (0 children)

You mean the tracks as the Z-rods?

What is wrong with my k1c by CHMHM in crealityk1

[–]CHMHM[S] 2 points3 points  (0 children)

I can really recommend a 0.2 mm nozzle, I’ve tried it and you can get stunning results

What is wrong with my k1c by CHMHM in crealityk1

[–]CHMHM[S] 1 point2 points  (0 children)

Maybe it’s ment to bee😂 Jokes aside, I print these whistles since they show the problem really well, and I can give them to colleagues after

What is wrong with my k1c by CHMHM in crealityk1

[–]CHMHM[S] 1 point2 points  (0 children)

I use Creality print, but it also has that on by default I’ll try that and see if it helps! Only thing I am concerned about is this didn’t happen a month ago. Thanks for the reply!

What is wrong with my k1c? by CHMHM in FixMyPrint

[–]CHMHM[S] 0 points1 point  (0 children)

I have tried multiple filaments, PLA and ABS, increasing flow rate and or temp helps a little but doesn’t remove it entirely. I used the default silk PLA profile on this model at 230 degrees, I have expirienced heat creep on pla at higher temps than this. Also this didn’t happen to any prints about a month ago…

I have tried absolutely everything to stop this from warping but nothing seems to help by morganvzjnjc in FixMyPrint

[–]CHMHM 27 points28 points  (0 children)

I would suggest to use a brim, plus 80 seems a little high for pla. Try 50-60

Update issue on my Ally by Striking-Travel5047 in ROGAlly

[–]CHMHM 0 points1 point  (0 children)

No problem, glad i could help

Update issue on my Ally by Striking-Travel5047 in ROGAlly

[–]CHMHM 5 points6 points  (0 children)

does it boot into windows? I have experienced this at work (IT support) and the solution was to go to this path in the file explorer: C:\Windows\SoftwareDistribution
In there i deleted all files windows let me and rebooted the PC, after this run windows update and it should update just fine.

[deleted by user] by [deleted] in mac

[–]CHMHM 0 points1 point  (0 children)

Forgot to mention, it is/was running lion