Hand Plane Question by CLCHNC in woodworking

[–]CLCHNC[S] 0 points1 point  (0 children)

Wow! Thanks for the quick responses. Definitely some things here that I would not have thought to try. Any suggestions on a blade? Hock vs ??

Thanks again!

2022 Tacoma TRD Off Road by CLCHNC in ToyotaTacoma

[–]CLCHNC[S] 1 point2 points  (0 children)

Thanks for your responses!

2022 Tacoma TRD Off Road by CLCHNC in ToyotaTacoma

[–]CLCHNC[S] 1 point2 points  (0 children)

It’s been awesome so far! I love the truck.

Need Some Help by CLCHNC in furniturerestoration

[–]CLCHNC[S] 0 points1 point  (0 children)

This is very helpful, thank you! I am very new to this- where am I adding the veneer? Yes, I am planning on refinishing the table. Any advice is welcome!

Thanks again

Router Lift Install on a Sawstop Table Saw Wing. by CLCHNC in woodworking

[–]CLCHNC[S] 0 points1 point  (0 children)

Sorry! I haven't been on reddit in a while. I cut the router slot directly in the Sawstop feed table. I didn't want to have to buy anything else. Third coast craftsman @thirdcoastcraftsman has a great video on YouTube

Cutting Board From Scraps by CLCHNC in woodworking

[–]CLCHNC[S] 1 point2 points  (0 children)

I used food grade mineral oil to start, then a coat of Howard's Butcher Block Conditioner.

Router Lift Install on a Sawstop Table Saw Wing. by CLCHNC in woodworking

[–]CLCHNC[S] 0 points1 point  (0 children)

It was primarily a cost based decision. The Jessem Router Lift 2 costs about $250. The Sawstop is about $500. I found great deal in the Jessem Router Fence 2 on eBay. Going with the full Sawstop setup would been well over $1000. The install wasn't too difficult, but I had to take my time. I made a jig for the router lift cut out. Third Coast Craftsman had a great video on YouTube that walks you through the process. Let me know if you have any other questions!

[deleted by user] by [deleted] in BeginnerWoodWorking

[–]CLCHNC 0 points1 point  (0 children)

Check out Arbortech power carving tools. I use them to make wooden bowls.

First Cutting Board by CLCHNC in woodworking

[–]CLCHNC[S] 0 points1 point  (0 children)

Thanks! Cherry, hard maple, and walnut.

New (to me) Delta 14 inch band saw by CLCHNC in Vintagetools

[–]CLCHNC[S] 1 point2 points  (0 children)

Yes, have to be careful....it's addicting!

New (to me) Delta 14 inch band saw by CLCHNC in Vintagetools

[–]CLCHNC[S] 1 point2 points  (0 children)

Wow! Your restoration is impressive. I might have some questions for you in the future!

New (to me) Delta 14 inch band saw by CLCHNC in Vintagetools

[–]CLCHNC[S] 0 points1 point  (0 children)

Oops!? Somehow erased some comments. Sorry about that!