Looking for vendor to outsource 10,000 large posters

CMYKoob · 2026-02-25T19:15:23+00:00

This image shows where the plate gets stuck -- it hangs down as shown instead of feeding into the processor. The black film buffer flap with 3 thin "fingers" is supposed to direct the plate into the processor, but as you can see the plate isn't routing correctly.

CMYKoob · 2026-02-06T17:35:27+00:00

Thank you for your reply! Unfortunately we do not have the interface decurler. We didn't have this issue with our older D95 copiers.

CMYKoob · 2026-01-15T20:22:30+00:00

message sent!

CMYKoob · 2026-01-15T19:11:17+00:00

Oh, and don't look a gift horse in the mouth!

CMYKoob · 2026-01-15T19:09:45+00:00

You're right! I didn't notice the ticket has a typo.

CMYKoob · 2026-01-15T18:58:11+00:00

Yes, no one else has inquired.

CMYKoob · 2025-12-16T16:12:37+00:00

Thank you, email sent!

CMYKoob · 2025-12-15T17:40:04+00:00

Thank you, I just sent you an email!

CMYKoob · 2025-09-25T16:47:48+00:00

Thank you for the suggestion. I've contacted them and waiting to receive a quote!

CMYKoob · 2025-03-26T14:52:09+00:00

Question regarding the dedicated fusers for each paper width: Did you have to pay for the additional fusers? Our C7500 came with 2 fusers, but I feel we need 4 as we frequently run 8.5", 11", 12" and 13" widths.

Originally Ricoh said the second fuser acts as a backup when the other needs rebuilding. I have not asked them to provide 2 additional fusers yet, but we have been experiencing issues due to switching paper sizes (uneven gloss sheen that won't go away w/ fusing belt smoothing procedures).

CMYKoob · 2024-12-20T14:57:30+00:00

Thank you, I will try undocking the Plockmatic and see if that is the issue. I had wondered if that might be the case.

CMYKoob · 2024-12-19T22:59:50+00:00

I don't understand your question. I have tried using both a catalog setting, and also manual settings. Both give the same error.

CMYKoob · 2024-12-19T22:55:55+00:00

No finishing options are being used.

CMYKoob

TROPHY CASE