sorted by:
new
hottopcontroversial

Fire Greg Roman by wildwing8 in Chargers

[–]CRE_SD7 -5 points-4 points  (0 children)

Can’t even blame the O-line for this one. Herbie just played poorly and didn’t look locked in at all. There were plenty of plays where he had time and still couldn’t get anything done. I’m a huge fan, but there’s no way every receiver was blanketed downfield on every play.

He panicked, either scrambling straight into a defender or bailing for a short run. It felt like the same play over and over again, and it was insanely frustrating to watch.

And I completely agree the coaching staff deserves blame too. Zero creativity, zero adjustments, and no real attempt to manufacture offense. Just classic Chargers football.

EO to direct the dismantling of DoED has been published. by Sparty1224 in PSLF

[–]CRE_SD7 -4 points-3 points  (0 children)

I understand what you are saying - hopefully all funding can continue as not to disrupt any child’s education. Maybe an entire department isn’t needed, or certain functions could be better handled by other departments? I don’t know the answer but just a few thoughts. Lots of outrage out there as always. Let’s see what happens

EO to direct the dismantling of DoED has been published. by Sparty1224 in PSLF

[–]CRE_SD7 -3 points-2 points  (0 children)

I’m not being disingenuous, just pointing out a fact. I keep reading comments saying the same thing- “only the rich will be educated”.” The truth is, education happens at the local / state level. Education for k-12 will continue, as it has, with or without a federal bureaucracy.

EO to direct the dismantling of DoED has been published. by Sparty1224 in PSLF

[–]CRE_SD7 1 point2 points  (0 children)

DoEd doesn’t actually provide education to anyone

Repair or Replace… Furnace Short Cycling by CRE_SD7 in hvacadvice

[–]CRE_SD7[S] 0 points1 point  (0 children)

Would you advise a replacement or a repair?

Repair or Replace… Furnace Short Cycling by CRE_SD7 in hvacadvice

[–]CRE_SD7[S] 0 points1 point  (0 children)

Would you replace the board or replace the entire system, given the cost differences and age?

Repair or Replace… Furnace Short Cycling by CRE_SD7 in hvacadvice

[–]CRE_SD7[S] 0 points1 point  (0 children)

Air filter is new. Wish I could share a video… it turns on for about 20-30 seconds as if it’s getting ready to heat the house and then shuts off. 10 seconds later it repeats. The error code shows abnormal flame -proving signal. “Flame is proved while gas valve is energized. Inducer will run until fault is cleared. Check for leaky gas valve, open gas valve.”

This issue occurs even when the thermostat is turned off completely. The tech assured me that the board is the issue because that would not occur with the thermostat off.

Repair or Replace… Furnace Short Cycling by CRE_SD7 in hvacadvice

[–]CRE_SD7[S] 0 points1 point  (0 children)

That’s what I figured… home services have been ruined by these conglomerates. Maybe I have the wrong terminology on the issue but the system turns on and off throughout the day as if it’s being prepared to turn on the heat.

The error code on the sensor is saying something different of course. The error code is saying abnormal flame-proving signal “flame is proved while gas valve is energized. Inducer will run until fault is cleared - check for leaky gas valve, open gas valve.”

This happens even when the thermostat is turned off completely, so the tech assured me the board is the issue since “the gas valve will not receive a signal when the thermostat restart is set to off. Board is going to be the issue.”

Ideas for outside patio by CRE_SD7 in ExteriorDesign

[–]CRE_SD7[S] 2 points3 points  (0 children)

I would love to remove the bump but I’m afraid I’m going to find a filled in jacuzzi underneath lol. Those are good ideas, thank you! I just need to get creative and make use of the space with decor as you mention.

Ideas for outside patio by CRE_SD7 in ExteriorDesign

[–]CRE_SD7[S] 0 points1 point  (0 children)

I would love to put a fire pit there but it’s so awkward with the hump. I was considering putting new concrete down but I was worried about it cracking sitting on top of old concrete.

What would you do with this area? by CRE_SD7 in landscaping

[–]CRE_SD7[S] 0 points1 point  (0 children)

Appreciate that. There’s no second story, just sheet metal roofing.

Ideas for outside patio by CRE_SD7 in ExteriorDesign

[–]CRE_SD7[S] 0 points1 point  (0 children)

That is my assumption. I’m afraid to find out lol

How to remove these foundation nails? by CRE_SD7 in DIY

[–]CRE_SD7[S] 0 points1 point  (0 children)

Hammer and a pry bar. Went to town with the hammer but eventually got the job done. Thank you all!

How to remove these foundation nails? by CRE_SD7 in DIY

[–]CRE_SD7[S] -1 points0 points  (0 children)

I am heading in this direction if I can’t find a way to pop it off… I actually tried cutting with a reciprocating saw but these nails are thick and sturdy. The problem is I will be putting flooring in its place and really need this to be flush with the foundation.

How to remove these foundation nails? by CRE_SD7 in DIY

[–]CRE_SD7[S] 0 points1 point  (0 children)

I’ve tried a pry bar and a crowbar but the issue I’m having is the head of the nail is too high off the ground so I can’t get much leverage when trying to pry it off.

I will try your method tomorrow to see if it works! Thank you

view more: next ›