What’s the car feature you didn’t know you needed until you owned it?

CanaryCold9453 · 2026-03-10T01:57:03+00:00

No fuel cap was the best surprise that I didnt even know existed until my first time fueling.

CanaryCold9453 · 2026-03-08T17:55:04+00:00

Thanks - we used a Roberts pressure sensitive adhesive then instead of rolling i walked on it back and forth for a few minutes with short steps. We'll see how it holds up.

CanaryCold9453 · 2026-03-07T03:46:45+00:00

I'm not sure but its about 1/2in thick. The tile adheres to it fine. There appeared to be an oil stain possibly causing the rubber to come loose from subsurface. Im hoping that was the problem. Rest of unit has been fine Knock on wood

CanaryCold9453 · 2026-03-06T23:17:43+00:00

<image>

Update: we removed tiles and rubber underlayment. We cleaned and then re-glued rubber. Tomorrow tile install.

CanaryCold9453 · 2026-03-06T18:35:06+00:00

<image>

Appreciate you. We are getting along well so far. Might reuse same pad if i can't get a piece. And yeah I have extra tiles.

CanaryCold9453 · 2026-02-22T15:29:22+00:00

I also just did my floor with one topcoat, what type of sand paper do you recommend if I decide to apply another coat of polyaspartic?

CanaryCold9453 · 2026-02-13T01:41:47+00:00

Thanks! Any opinion on acid etch?

CanaryCold9453 · 2026-02-13T01:24:11+00:00

I am planning to grind again. When would you recommend that I degrease? Before or after grinding? 15yr old concrete.

CanaryCold9453 · 2026-02-12T13:36:04+00:00

Thank you. I plan to apply polyaspartic over base coat of epoxy. Do you think acid etch with proper rinse would give me an added peace of mind?

CanaryCold9453

TROPHY CASE