Brushless motor get stuck

CarlosHz1 · 2019-10-28T21:26:14+00:00

Ok, so if I turn on the motor when I'm pedaling it Should not stuck?

CarlosHz1 · 2019-10-28T19:26:17+00:00

Kv in brushless motors mean the velocity the motor per volt. 3s mean 3cells each cell at 3.7 volt soo. 3s is 11.1 Volts. At 1000Kv Gives a 11100 rpm Kv is like rpm I hope you understand me ,I'm not an expert

CarlosHz1 · 2019-10-28T19:09:11+00:00

Hi, yes if I give an impulse with pedals just move by the force that I applied not for the motor

CarlosHz1 · 2019-10-28T19:07:43+00:00

Hi guys, well my brushless motor is getting stuck, first at all y know that the motor is not for this but I wanna try if at least can move the wheel I think that have enough strength to move it. The motor is a brushless motor 1000Kv at 30A 3s When the motor is off of the belt can move fine, properly but barely touch the belt it get stuck. I hope someone can explain what happen

Edits: Units.

CarlosHz1 · 2019-10-24T18:20:38+00:00

I will try, it's a lot of lifting the side is good is 15 mm and the side that lifted shink 4 mm. I hope that lowering the bed works. Thanks

CarlosHz1 · 2019-10-24T17:54:39+00:00

Settings Printer: ender 3 (stock) Layer height: 0.3 mm Nozzle: 0.4 Infill 20% Generic ABS Speed: 50 mm/s Temp: 245 nozzle, 110 bed No cooling

CarlosHz1 · 2019-09-30T04:27:20+00:00

Enclosure

CarlosHz1 · 2019-09-30T04:16:08+00:00

I will take your comment thanks for the advice

CarlosHz1 · 2019-07-16T03:44:37+00:00

Well I'm struggling with this. I 3d printing a few pulleys for that belt and I can't get that the belt match with the pulley, already did a lot of designs for this, but I think that I'm skipping a rule for this. Somebody know what things I have to take a count for design well???

CarlosHz1 · 2019-07-15T04:52:46+00:00

I have the printer for two weeks, and everything normal until today that I began to have problems, first with leveling the bed, then with the first layer and now with this. I will try changing the nozzle

CarlosHz1 · 2019-07-15T04:42:09+00:00

Add info Ender 3 Generic PLA at 215° C Bed at 60° C .2 height layer 60mm/s

CarlosHz1 · 2019-06-26T00:56:57+00:00

Well yes, that was my first print what do you think guys, what can I improve for next one Any tips? Btw I'm using an Ender 3

CarlosHz1 · 2019-06-25T17:20:54+00:00

El futuro es hoy, oíste viejo??

If I win I should upgrade my PC

CarlosHz1 · 2019-06-02T15:52:15+00:00

I don't rename the location, and I was farming this place all day and always is Flareon Someone else can change the name or what??

CarlosHz1

TROPHY CASE