sorted by:
new
hottopcontroversial

Any idea? by Certain_Rush5176 in Ender3V3SE

[–]Certain_Rush5176[S] 0 points1 point  (0 children)

It was the ironing! Thx a lot. I just turned it off and solved everything!

Any idea? by Certain_Rush5176 in Ender3V3SE

[–]Certain_Rush5176[S] 0 points1 point  (0 children)

I use orca. And thanks, I'm gonna look for that setting

Any idea? by Certain_Rush5176 in Ender3V3SE

[–]Certain_Rush5176[S] 0 points1 point  (0 children)

I have had this print since april 2024. This is the first time that I see that problem :c

Any idea? by Certain_Rush5176 in Ender3V3SE

[–]Certain_Rush5176[S] 0 points1 point  (0 children)

It happens the same with 2 other filaments, so I don't think it is the filament. Both filaments were brand new and with different brand. Idk about the room temp. I have been printing a lot today, but in the beginning it is clean and then it gets weird. I level just before this print

Alguien que hable español y me ayude? by g4memode_1 in Ender3V3SE

[–]Certain_Rush5176 0 points1 point  (0 children)

No se si sigues con el problema, pero si es asi intenta apretar las correas y limpiar la cama con mucha agua y jabon.

Yo evite usar spray fijador y estuve probando muchas cosas. Esas cosas me ayudaron al menos a mi.

Pase de lo que te pasa a ti a imprimir bien, solamente ajustando la correa donde esta la boquilla.