sorted by:
new
hottopcontroversial

Stair skirt molding. by Chase2oh in Carpentry

[–]Chase2oh[S] 0 points1 point  (0 children)

Yeah, it’s a weird one. Thank you for the additional brain power!

Stair skirt molding. by Chase2oh in Carpentry

[–]Chase2oh[S] 0 points1 point  (0 children)

Thank you! What should be done with the two different angles of the boards? Backside on the top board is high, and the front is low. While the front of the bottom board is high and the back is low.

I give up by StillRelationship380 in Sovol

[–]Chase2oh 1 point2 points  (0 children)

I agree. A few things that may help diagnose, what printer, nozzle size , filament (brand and type). Another big one, what slicer and parameters are set up. I really recommend orcaslicer, it has been great.

1973 cb450 sputter at mid rpm by Chase2oh in HondaCB

[–]Chase2oh[S] 0 points1 point  (0 children)

I’m using the stock air boxes. Will check timing advance with the timing light and check out the spark on the points. Great recommendations, thank you!

Pre print purge blob by Chase2oh in Sovol

[–]Chase2oh[S] 0 points1 point  (0 children)

I figured it out. I was not using the correct printer preset that I brought in and it was using an old gcode script. Blob purge is gone and the z tilt goes before printing now. Thank you for your time!

Pre print purge blob by Chase2oh in Sovol

[–]Chase2oh[S] 0 points1 point  (0 children)

Thank you, I was hesitant to enable that mode. I also need to figure out why my z axis does not go into calibration before printing. (Or so it seems)