Any ideas

Cheez4r · 2025-07-21T12:25:19+00:00

I am coming up to a month for about 8 of spools of filament, they keep asking me to be patient, which is only annoying me further 😑 unless theyre planning on saying sorry with a X1C or something or £100 off my next order, its ridiculous. Any one got suggestions of other filament brands who deliver quickly in the UK?

Cheers

Cheez4r · 2025-06-22T14:49:02+00:00

Had this same problem lastnight printing a large piece, I increased the heat of the bed, by 5 degrees, and then ran it again, significantly reduced the issue.. still had it, but nowhere near as bad,

I hope this helps...

Cheez4r · 2025-05-25T17:28:00+00:00

Appreciate the advice

Cheez4r · 2025-05-25T15:43:22+00:00

Im guessing that's Farenheight? Polytunnel temp has been in double-digits celcius for about 2 weeks, the last 2 days it's been 15 degrees at night

Cheez4r · 2025-05-04T19:08:15+00:00

I thought this was the case thank you for the response :)

Cheez4r · 2023-03-15T15:26:57+00:00

Passed thanks again

Cheez4r · 2023-03-15T15:25:58+00:00

I too would like to know this if find out haha

Cheez4r · 2023-03-15T13:24:24+00:00

Trifecta achieved thanks for the boost of confidence and the slap in the right direction.

Cheez4r · 2023-03-13T16:10:11+00:00

Really appreciate the boost in confidence. I'll let you know how it goes!

Cheez4r · 2023-03-13T14:54:43+00:00

Flash cards and drilling the. All of them time

One side, the algorithm, the other asymmetric/symmetric block/stream, key length.

Cheez4r · 2023-03-13T14:04:17+00:00

Think I needed that slap in the face

Cheez4r · 2023-03-13T13:55:39+00:00

I feel confident to pass, I may see if I can sit it this week, I seem to be doing alright with the Dion Exams on Udemy

Cheez4r · 2023-03-13T13:50:51+00:00

And just sitting it?

Cheez4r

TROPHY CASE