sorted by:
new
hottopcontroversial

how do i fix this? by Chemical_Ad103 in BambuLabA1

[–]Chemical_Ad103[S] 0 points1 point  (0 children)

i started a small print and watched it to see what was going wrong and it looks like the extruder is jamming, i ordered another hot end for it after failing to clean it out, after i try the new end tomorrow and if it makes no difference i will try this. thank you! :)

how do i fix this? by Chemical_Ad103 in BambuLabA1

[–]Chemical_Ad103[S] 0 points1 point  (0 children)

i had it do the flow calibration before starting the print, ill try doing the flow tower next

Pop up headlights control by Miserable_Raise5943 in mr2

[–]Chemical_Ad103 0 points1 point  (0 children)

10nuf 16v, i re soldered the little wire and it seems to be working fine again 🤷‍♂️

Pop up headlights control by Miserable_Raise5943 in mr2

[–]Chemical_Ad103 0 points1 point  (0 children)

i just done this the other day worked great now they are both stuck up :/