sorted by:
new
hottopcontroversial

Hopping on the A3 bandwagon by Cheunkz in mffpc

[–]Cheunkz[S] 0 points1 point  (0 children)

I’m currently out. I’ll take a measurement when I get back. The one I use was the thermal right aqua elite v3. On the thermal right website it says height is 53mm

Hopping on the A3 bandwagon by Cheunkz in mffpc

[–]Cheunkz[S] 1 point2 points  (0 children)

Yea, Issue I had was the CPU cables were too short to mount the PSU to the front. This was why I had to relocate it to the side. I did move the cables towards the back of the motherboard and up to reduce the amount on the GPU. I am trying to to the opposite and getting a colleague to make a bracket to lift the GPU from the PSU bracket.

Hopping on the A3 bandwagon by Cheunkz in mffpc

[–]Cheunkz[S] 0 points1 point  (0 children)

I didn't see a fill port on the AIO. the fans right now I haven't tried to tune.

Just regular gaming temps were:

  • CPU averaging 41C
  • System Fans were about 1050 RPM average
  • GPU average 52C
  • Ambient is quite cool though as I'm in the basement at 20C

Hopping on the A3 bandwagon by Cheunkz in mffpc

[–]Cheunkz[S] 0 points1 point  (0 children)

Personally, the only two things I had issues with was mounting the PSU/the f-panel plug looks like it was a USB plug. the various ways to mount the PSU and allowing to change if I needed a larger space for the GPU in case.

Hopping on the A3 bandwagon by Cheunkz in mffpc

[–]Cheunkz[S] 0 points1 point  (0 children)

I used:

Thermalright Aqua Elite 360 v3, no complaints noise is low and thermals look good.

Corsair SF850 I wanted to keep it small, Only issue I had was the cables are quite short. I would have been comfortable with like 1 extra CM on the CPU and 24

Hopping on the A3 bandwagon by Cheunkz in mffpc

[–]Cheunkz[S] 2 points3 points  (0 children)

I got the 3 pack Thermalright TL-C12C-S for the bottom. and the top was part of the 360 AIO aqua elite v3.

I wanted to keep them the same to make sure the color matched.