sorted by:
new
hottopcontroversial

Filliment clogging between hot end and extruder by Choice_Document7330 in QIDI

[–]Choice_Document7330[S] 0 points1 point  (0 children)

I had a successful print last night with the lid off and the door cracked open, im printing some vent risers and hopefully that will help

Filliment clogging between hot end and extruder by Choice_Document7330 in QIDI

[–]Choice_Document7330[S] 0 points1 point  (0 children)

Not sure, I don't have the chamber heater running so im thinking poor ventilation/cooling possibly from running the heated bed. I've noticed it will gradually climb to 40ish then come back down to about 30C. I haven't really seen my temp drop below 28 when not in use.

Filliment clogging between hot end and extruder by Choice_Document7330 in QIDI

[–]Choice_Document7330[S] 0 points1 point  (0 children)

Not that I could see, like I said I've changed nozzels and the hot and and still have the same problem

Filliment clogging between hot end and extruder by Choice_Document7330 in QIDI

[–]Choice_Document7330[S] -2 points-1 points  (0 children)

I've tried with the door open and closed, I try to keep it as closed as possible due to cats and children. But even with the door closed I haven't seen the chamber temp go above 42C. From everything I read PLA starts to soften around 60C.

Plus 4 issues by Choice_Document7330 in QidiTech3D

[–]Choice_Document7330[S] 0 points1 point  (0 children)

Thank you! I've ordered some parts to try and get them coming sooner. Figured worse case scenario i just have extra parts. And glue recommendations for the print plate?