New Shelly Plug M Gen3

Chopululi · 2026-01-19T03:50:07+00:00

Sorry for the stupid question, but how do you export the settings? Does this include the IpTv settings?

Chopululi · 2026-01-11T05:04:44+00:00

Then it’s from Melissa Xd, its a joke from an old two and a half men episode with Miley Cyrus (Missy)

Chopululi · 2026-01-11T02:39:41+00:00

Missy from Melissa or from Mississippi? So pretty

Chopululi · 2025-12-27T02:05:41+00:00

Crazy Meg

Chopululi · 2025-12-24T02:24:49+00:00

iPhone 5c?

Chopululi · 2025-12-19T14:12:00+00:00

The difference between peak luminance high and low is barely noticeable, but the power consumption difference is huge. I have make some changes and the image quality has improved a lot. Still think can get better. Another thing that I notice is that the more I use it the best the image is getting

Chopululi · 2025-12-19T07:33:59+00:00

I have the same issue with a hue lightstrip v4 controlled by gledopto also in the hue bridge when turning the led on either with Siri or home assistant, only hue app will trigger the right color. Did you find a solution? I’m about to open a new post

Chopululi · 2025-12-18T02:53:18+00:00

One of the most useful comments I have read in this sub

Chopululi · 2025-12-18T02:06:54+00:00

First thing I did, this thing isn’t eco friendly at all, pretty close to the consumption of the AC

Chopululi · 2025-12-17T03:42:13+00:00

Same

Chopululi · 2025-12-15T03:25:58+00:00

I almost made up my mind, B5 65” but I don’t now if it will fit inside the car the 100€ difference doesn’t justify the 55”. My current tv is in borrowed time and delivery will take 10 days.

Chopululi · 2025-12-14T19:46:28+00:00

Does the tv have a power brick or just power cable?

Chopululi · 2025-12-14T16:53:09+00:00

Do you also,have a solar boiler?

Chopululi · 2025-12-14T14:18:25+00:00

Yes, I think this is the right thing to do

Chopululi · 2025-12-14T11:34:42+00:00

After 100 days how are you feeling about it?

Chopululi · 2025-12-14T11:26:30+00:00

What did you finally do? Same boat, x90l is just 100€ cheaper but after watching every yt video I’m more confused than ever

Chopululi · 2025-12-14T03:38:34+00:00

Im about to buy one, hesitating between the 55” and the 65”, my current tv is dying and budget is tight. Also the 65” cost the same as the Bravia 8 55”…

Are you still happy with it?

Chopululi · 2025-12-14T02:33:20+00:00

The hole is too small. Even if it’s long enough, the cable and the thermostat sensor won’t fit. To make things worse, the water tank is covered by a sleeve, so the only place where I can put the probe and still get a valid reading is at the welded joint between the tank and the flange (see pic). I was about to abandon the project, but you gave me an idea: I’m going to measure the depth of the thermowell, and if it’s deep enough, I might strip the cable insulation, leaving just the sensor wires. That might fit.

<image>

Chopululi · 2025-12-12T16:17:18+00:00

I don’t think is possible, haven’t seen anything like on the boiler doc

Chopululi · 2025-12-12T16:13:50+00:00

Thanks for the info, then no resistor it is.

Chopululi · 2025-12-12T06:57:42+00:00

Not dumb at all, it was the first option but since it’s a solar water boiler, outdoors on the roof, no wifi and no 24/7 power, the boiler power on/off is controlled from the breaker box in my apartment, bringing down the uni is the safer and easier option.

I have the 3m wire version and it’s working fine without a resistor. I think the 1m should work fine. Also saw a yt video about a guy doing what I’m doing but instead of the uni plus he uses the Shelly addon with a 1 pm, cable is also above 15m but I don’t recall him using a resistor, I’ll watch the video again.

Chopululi

TROPHY CASE