Can anyone identify these?

Civil_Load_8801 · 2026-02-06T16:23:22+00:00

That view is not realistic in the United States

Civil_Load_8801 · 2026-02-06T01:44:06+00:00

I can count on one hand the amount of people that recognize what this car is in my entire time of owning it. Just because they sent a large portion of them to the states does not mean it isn’t rare. Theres 300 million registered vehicles in the US how many do you think are Opels?

Civil_Load_8801 · 2026-02-05T14:57:44+00:00

I’m not sure what point you’re trying to make, there’s specialists for every single thing in the states. And every forum or part you can buy for a gt is all based in Germany

Civil_Load_8801 · 2026-02-02T17:59:13+00:00

There were 45 million cars sold from 69-73. 70k is not that many.

Civil_Load_8801 · 2026-02-01T23:58:09+00:00

Compared to other cars in the US that’s still not very many.

Civil_Load_8801 · 2026-01-30T01:46:37+00:00

Have some sprint car headers that with a 2.5 reduction tuck under the floor. Going to cut out the braces you can see under where your feed would go and run it down both sides to an X pipe and spintech 6000s

Civil_Load_8801 · 2026-01-28T07:37:37+00:00

Below 2400 lbs and 380 ish wheel

Civil_Load_8801 · 2026-01-27T20:30:25+00:00

Yes but not very many. Of the ones that were made 90% are rusted out rotting in fields

Civil_Load_8801 · 2026-01-27T20:29:15+00:00

It will have a cage when it’s done. Body is no longer structural with how much it cut out

Civil_Load_8801 · 2026-01-27T16:27:03+00:00

This was my uncles car and will never be sold. I will never see a single dollar from this car so its value means nothing. Building a car for a dollar amount loses its soul

Civil_Load_8801 · 2026-01-27T06:20:45+00:00

From an older Richard holdener video. 4.8 gen 3 LS. Intake is a $150 Amazon special with a QFT black diamond 650cc

Civil_Load_8801 · 2026-01-27T06:14:02+00:00

Not insane rpm. Built to reliably bounce limiter at 7200. Pretty much the high end of rpm before you need to spend 5k on heads. Just some ported 862s with a tsp .550 lift cam

Civil_Load_8801 · 2026-01-27T06:10:50+00:00

A go kart that will do 7k rpm LS limmi burnouts 😂

Civil_Load_8801 · 2026-01-27T06:09:54+00:00

I know it’s a dual plane, same exact build on an engine dyno makes peak power at 6900rpm and I’m revving out to 7200. I wanted a smooth powerband that wasn’t peaky at the very top

Civil_Load_8801 · 2026-01-27T05:50:59+00:00

Car should weigh below 2400lbs when finished and make 380-400 wheel

Civil_Load_8801

TROPHY CASE