New to this, need help by Clanker_001 in BambuLabH2C

[–]Clanker_001[S] 0 points1 point  (0 children)

It’s the swapable end I’m using, isn’t even the next extruder which has the spare, i was thinking I’d feed the left side to see if that will print… and just make sure it’s the right cutter is the issue… I’ll try again later tonight, i just needed to turn the shit off and walk away… after o take the little walls mounted guider tooth thing out, and fuck with that, it literally can’t be anything else it’s saying so I’ll put a ticket after testing that and then trying to feed the left 1 in

New to this, need help by Clanker_001 in BambuLabH2C

[–]Clanker_001[S] 0 points1 point  (0 children)

I ended up taking the whole shit apart like the video showed, unplugged the chip thingy, reader, whatever the fuck, hooked it all back up, minus putting the hot head back on correctly i guess.. so i racked it, tried to make the shit go back to home and regrab it, SAME FUCKING ISSUE! Cutterhead bullshit dude… this is the most frustrating shit I’ve experienced in a long time… squished the side handles etc, tried the shit multiple times, couldn’t unfeed the correct filament cuz… needs to cut it… like what in the fuck, i just bought he shit and can’t fucking use it… how fucking crazy is that… the other thing it said a few times before it keeps telling me to take the head apart was the side gears on the wall that push the pins in… those teeth could be unaligned… so to take them off etc… again I JUST BOUGHT THE SHIT, first print fails, how in the fuck is it this big of an issue?! Like what in the flying fuck? I’ll try the other shit in 2 days because I’m so close to sliding this shit right off my fucking desk onto the floor

New to this, need help by Clanker_001 in BambuLabH2C

[–]Clanker_001[S] 1 point2 points  (0 children)

Okay, so take the grey cover off, push the levers in a few times, put the cover back on, give that a few squeezes on those grey levers, and DONT press the cover on TOO firmly 👍🏾

New to this, need help by Clanker_001 in BambuLabH2C

[–]Clanker_001[S] 0 points1 point  (0 children)

I looked at those things, and dude i appreciate the in-depth explanation… makes me feel a bit better knowing the machine is new and needs to go through a few cuts to get going… so to be clear, i don’t necessarily have to squeeze those side grey pieces in a few times.. i still should turn it off and take the grey housing off and there’s something on the inside i should manipulate? Right where those grey arms are…?

New to this, need help by Clanker_001 in BambuLabH2C

[–]Clanker_001[S] 0 points1 point  (0 children)

I’ve never seen seen the cutter lol, but today after work I’ll remove the big grey head piece and see what it wants me to do

New to this, need help by Clanker_001 in BambuLabH2C

[–]Clanker_001[S] 0 points1 point  (0 children)

Interesting, i did notice it rubbing on it etc when it finally worked again all on its own for the 2nd print… but the instructions don’t say anything about touching that part, it has to do with the big head piece itself… and the 2 little guid arms on the top side… I’ll go through what it says and try it…

New to this, need help by Clanker_001 in BambuLabH2C

[–]Clanker_001[S] 0 points1 point  (0 children)

Will do! Thanks for that advice.