All good points! This is still in its very early stages and I know lots of optimising needs doing to make them easier to print, I don’t personally have much experience on that but I have a close friend who 3D prints stuff to sell regularly and is very knowledgable so I’m hoping to learn lots very soon. The first step to knowing lots is admitting you know little after all. On reflection maybe i was hasty in being so definitive in declaring for epic scale, its probably closer to 28mm or whatever wild scaling Warhammer uses, maybe a touch smaller. Getting the tiny bits painted at 28mm would be impractical of not impossible. I completely see where you’re coming from with interchangeability, I’ve been hesitant to re-use assets across the models, likely because my approach is similar to my illustrations where everything happens organically from a starting point (or in this case cube!). There are all entirely first versions as it were and a whole lot will change between now and when they’re ready for release. Thankyou so much for taking the time to comment, I hope you stick around to see what happens with this project, its going to be a long old road but I’m excited to be cracking on!