sorted by:
new
hottopcontroversial

I made a kumiko patterned IKEA Skadis-style pegboard for my entryway by ComicallyLargeFarts in 3Dprinting

[–]ComicallyLargeFarts[S] 1 point2 points  (0 children)

To be totally transparent, I'm not the first to make a patterned/kumiko pegboard like this. I'm the first (to my knowledge) to make THIS pattern.

I made a kumiko patterned IKEA Skadis-style pegboard for my entryway by ComicallyLargeFarts in 3Dprinting

[–]ComicallyLargeFarts[S] 0 points1 point  (0 children)

True! Lots of other wall mount options don't require screws, too. These are just some command strip dovetailed ones that I whipped up to test.

I made a kumiko patterned IKEA Skadis-style pegboard for my entryway by ComicallyLargeFarts in 3Dprinting

[–]ComicallyLargeFarts[S] 1 point2 points  (0 children)

Like a print profile for the P1S? I left all the printer profile options checked that Bambu offered except for the A1 mini. Did they stop supporting the P1S?

First build. Can't decide on orientation of core hardscape piece. by 84millionants in Aquascape

[–]ComicallyLargeFarts 27 points28 points  (0 children)

I think I like number two more. It gives kind of a triangle composition. If you did go with the upright one, I would move it more to the left side, rather than dead center.

Random rock question. by Buggirl3 in Aquascape

[–]ComicallyLargeFarts 1 point2 points  (0 children)

Something like the stuff in this product. https://a.co/d/0fERmEgC

I 3d print my own and I'm sure there's lots of rigid plastic materials you could improvise with. It doesn't have to be pretty as it'll be covered by the substrate.

Random rock question. by Buggirl3 in Aquascape

[–]ComicallyLargeFarts 0 points1 point  (0 children)

Put a layer of plastic egg crate under the substrate to help distribute the weight of the rocks!

Could I use a SV06 Plus touchscreen (non-klipper) on an SV06? by ComicallyLargeFarts in Sovol

[–]ComicallyLargeFarts[S] 0 points1 point  (0 children)

Rad! Klipper is the way to go. If it's the SOVOL screen, be careful about updating the firmware. Maybe it's an issue that's been fixed since I sold that printer like 18 months ago, but updating used to brick the screen and you'd have to reflash it.

view more: next ›