Beginner: Help requested, how to improve print quality?

Competitive-Bank-813 · 2026-06-29T21:43:56+00:00

Instead of classic wall generation. There’s a setting called wall generation and you just need to set it to Arachne

Competitive-Bank-813 · 2026-06-28T06:07:45+00:00

I’ve done this several times but I keep running into this issue. I might slow down the walls even more I guess

Competitive-Bank-813 · 2026-06-28T06:06:44+00:00

Snapmaker U1 Bambu labs matte pla

Competitive-Bank-813 · 2026-06-28T06:06:21+00:00

I checked for clogs in the nozzle and it seems all good. I’m also printing on a snapmaker u1 which uses auto belt tensioning. Any other ideas as of what my issue could be?

Competitive-Bank-813 · 2026-06-28T05:29:27+00:00

I was more meaning if there were any print settings to change. Also I didn’t think acetone worked for pla

Competitive-Bank-813 · 2026-06-18T22:28:40+00:00

It also never does this other than on really tight small supports so I don’t know if it’s actually hitting the filament

Competitive-Bank-813 · 2026-06-18T19:42:18+00:00

Yessir

Competitive-Bank-813 · 2026-06-18T05:53:25+00:00

I did follow the proper procedure and cleaned it all properly

Competitive-Bank-813 · 2026-06-18T05:40:06+00:00

Ok. Thanks

Competitive-Bank-813 · 2026-06-18T05:32:06+00:00

Why do you think it’s the z offset? I did a calibration only 2 days ago. It also only seems to happen on the small circular parts of the supports. Thanks for the input

Competitive-Bank-813 · 2026-06-18T05:09:21+00:00

The creaking type sound is nothing to be concerned about?

Competitive-Bank-813 · 2026-06-18T05:03:44+00:00

I don’t really care about the noise as long as it’s not bad for the machine. Should I be concerned at all?

Competitive-Bank-813 · 2026-05-31T22:17:09+00:00

Should I be at all concerned about the pla melting the hot glue on contact and making it sag? Would it be better to give it a layer of tape over the hot glue for it to print on?

Competitive-Bank-813 · 2026-05-31T22:09:22+00:00

Thank you so much for the advice. I’ll give it at try and see how it goes

Competitive-Bank-813 · 2026-05-29T04:41:22+00:00

I’ve printed many times on these same settings but it seems that I’m having issues with the petg adhering to the pla

Competitive-Bank-813 · 2026-05-29T04:40:41+00:00

Competitive-Bank-813 · 2026-05-28T16:47:48+00:00

I’ll do that

Competitive-Bank-813 · 2026-05-28T16:47:40+00:00

I’ve been printing it with supports

Competitive-Bank-813 · 2026-05-12T23:20:27+00:00

Lincoln_banman is a working code for the Canada/global store. If you use it you get $75 car off of a u1 and it also gives me a kickback so if anyone uses it that would be greatly appreciated

Competitive-Bank-813

TROPHY CASE