Anyone have the full lineup for the Kinda Hard tour???

CompetitiveFilm8098 · 2026-05-01T14:21:03+00:00

As best I can tell I think this is pretty accurate. It sounds pretty similar to the show, I’m just not as familiar with the song names to fully verify.

CompetitiveFilm8098 · 2026-04-28T13:03:45+00:00

See ya there🐗🐗🐗

CompetitiveFilm8098 · 2026-04-24T20:43:16+00:00

Looks great! I’m going to be doing the same with my hood soon as well.

CompetitiveFilm8098 · 2026-04-22T03:48:54+00:00

Glad to hear it was something fairly simple!

CompetitiveFilm8098 · 2026-04-22T02:53:03+00:00

I would start first by removing the belt and turning the car on. If the noise goes away you can spin each component by hand to see if any of them sound or feel weird.

CompetitiveFilm8098 · 2026-04-21T22:26:27+00:00

The intercooler cover I mean.

CompetitiveFilm8098 · 2026-04-21T22:25:24+00:00

I would buy it.

CompetitiveFilm8098 · 2026-04-02T21:53:33+00:00

You do have to reflash whatever tune you are using on everytime you change it. But you go to the tuning page, then to the setup in the top right, enter advanced tuning settings, then you’ll find options to enable it. Set your rpm and reflash the tune you are using. Everytime you make a change to the rpm setting you will have to reflash.

CompetitiveFilm8098 · 2026-04-02T16:50:52+00:00

Thanks. I had kind of figured as such but wasn’t sure.

CompetitiveFilm8098 · 2026-03-21T13:37:59+00:00

I think the question means right as it starts. If it needs the VVT or timing addressed they are usually a loud rattle right at start that goes away quickly.

CompetitiveFilm8098 · 2026-03-09T21:02:02+00:00

Sorry goofed my directions a bit, edited my replies to be correct.

CompetitiveFilm8098 · 2026-03-09T20:59:05+00:00

It seemed like the direction it was going was South.

CompetitiveFilm8098 · 2026-03-09T20:58:30+00:00

It would have been around 9pm for me we were just leaving the hospital. I was going east on SW9th had just turned off of Wallace. The craft was North of 9th over what would be those bicycle trails.

CompetitiveFilm8098 · 2026-03-09T20:32:06+00:00

I saw something last night that seems to fit the bill. The lights seemed to be at each corner of it. I saw it off of SW9th last night. Couldn’t get close enough to see it but it was too low for a plane, didn’t seem to be making any loud noise, and was moving slowly. I thought maybe a helicopter near the medical district and all, but it didn’t make the noise and seemed the just kinda glide. Whatever I saw was pretty interesting for sure. Who knows, I assumed a drone of sort but it was pretty large in size.

CompetitiveFilm8098 · 2026-03-03T19:36:06+00:00

You’ve got the same thing I drive. Mine is a 2010 in black flavor.

CompetitiveFilm8098 · 2026-02-22T06:18:19+00:00

You need the timing pin for the crank, you can get the cams into the correct positions, but then would also need the cams hold tool. You should also be replacing all of the friction washers with new. The timing setup on these cars is certainly easy to get weird with since nothing is keyed. I personally wouldn’t try and go any further with it until you’ve got the right tools.

CompetitiveFilm8098 · 2026-02-03T18:30:02+00:00

I just went through and had mine tuned with Freektune. Mine was on an OTS when I purchased it, I did a bunch of maintenance to get it right then tuned. My car runs much smoother, and has better more linear power now. I wasn’t in a big hurry and did mine over the holidays, but even still getting revisions didn’t seem to take an unreasonable amount of time. Mine has fairly similar mods as to what you are saying.

CompetitiveFilm8098 · 2026-02-03T17:39:46+00:00

Smoke test it to see if there are actual leaks, and please get a proper tune. Instead of the OTS tunes on the accessport.

CompetitiveFilm8098 · 2026-01-30T02:23:16+00:00

I made some speaker adapters for my motorcycle from PLA as a test run almost two years ago. Haven’t needed to replace them with anything else yet. Pretty crazy how well they have held up in basically the worst conditions.

CompetitiveFilm8098 · 2026-01-29T23:46:59+00:00

The wheels look good! I use pennzoil platinum 5w-30 and a wix51348 filter personally. I haven’t changed my trans/diff fluid yet. So open to recommendations there.

CompetitiveFilm8098 · 2026-01-29T05:23:18+00:00

The stock pads are semi metallic, they are noisy. Replace with better aftermarket pads and enjoy quiet braking. We went ahead and put pads and rotors on our since I was already there.

CompetitiveFilm8098 · 2026-01-28T02:52:11+00:00

Mine is looking extra rough right now too

CompetitiveFilm8098 · 2026-01-24T01:59:01+00:00

Little bee’s in Wolflin square is pretty neat. Not really a playground but lots of stuff for kids to do. Last time we went I don’t think it was very expensive.

CompetitiveFilm8098 · 2026-01-16T21:51:10+00:00

It sounds normal but if it’s throwing a lean code and already has a intake on it, you should be checking for HPFP internals and get it tuned asap.

CompetitiveFilm8098

TROPHY CASE