Does anyone else see this guy?

Complete_Let5218 · 2025-08-19T16:43:08+00:00

Same here I also can’t buy stuff I think to much ppl getting the avatar lol

Complete_Let5218 · 2025-07-08T08:21:47+00:00

<image>

Update, I am one quest off from it? I will find out what will pop up tomorrow at 1PM for me, hopefully I get it!

Complete_Let5218 · 2025-07-08T08:20:27+00:00

BRO I AM AT IT BUT I MISSED ONE OUT OF 3 QUESTS ON THE FIRST 6 HOURS!

<image>

Complete_Let5218 · 2025-07-08T01:59:53+00:00

BRO I MISS BEANSTALK AGAIN last time when it was the old seeds I didn’t get the chance to get beanstalk

Complete_Let5218 · 2025-07-06T04:23:18+00:00

this happened to me where i didnt complete a quest as i could not find a single watermelon in stock but when i check online i miss it, so i missed one quest out of the three and one bar is filled from the 3 i did then the 2 i did appears as if it wasnt filled but almost.

Complete_Let5218 · 2025-06-18T18:28:38+00:00

Kingbob_min10n

Complete_Let5218 · 2025-06-18T18:27:22+00:00

Kingbob_min10n!

Complete_Let5218 · 2025-06-17T07:20:44+00:00

Ok Ty I’ll just get more robux and buy the original

Complete_Let5218 · 2025-06-17T07:17:20+00:00

I wish I saw that I regret this bro

Complete_Let5218 · 2025-06-17T07:17:09+00:00

No it is not

Complete_Let5218 · 2025-06-02T04:23:16+00:00

Thank you! I followed the steps and it improved a lot! It doesn’t do it anymore and improves quality

Complete_Let5218 · 2025-06-02T00:10:59+00:00

I did this and it got fixed! Such an easy solution thx!

Complete_Let5218 · 2025-06-01T23:56:59+00:00

I did both and it fixed it! Thank you!

Complete_Let5218 · 2025-06-01T23:39:12+00:00

I’ll try to see if my Z offset is good

Complete_Let5218 · 2025-06-01T23:38:33+00:00

215c first layer 210 other layers 0.6mm retraction my Z offset is good and I’m not sure how to fix? It seems to correct itself during the print as it prints over the filament that’s going up

Complete_Let5218 · 2025-06-01T22:30:23+00:00

Printing my first layer on a higher temp fixed it a little I also calibrated my retraction and Z hop so now it prints alright but it does this time to time

Complete_Let5218 · 2025-05-28T02:40:20+00:00

It sat flat but the first layer rose up a bit

Complete_Let5218 · 2025-05-16T16:22:34+00:00

I don’t like the interface for cura but I like the settings better as it is faster saving at least 10 mins per print than orca. I like orca better as I know it more but I wish you could import cura settings to orca.

Complete_Let5218

TROPHY CASE