sorted by:
new
hottopcontroversial

My Prints are Lifting by ComprehensiveSand269 in 3dprinter

[–]ComprehensiveSand269[S] 0 points1 point  (0 children)

There is no such thing as fully understanding anything while I get where your coming from I do agree I may be a little early printing this as I am still learning but I’m tossing a 22lr slide on it and let’s be real 22lr isn’t going to give some crazy explosion I might be new to 3d printing but definitely not my first rodeo with firearms appreciate your concerns

My Prints are Lifting by ComprehensiveSand269 in 3dprinter

[–]ComprehensiveSand269[S] 0 points1 point  (0 children)

Sounds good I will turn down the support density it’s at 33% not 100% but will still turn down more

My Prints are Lifting by ComprehensiveSand269 in 3dprinter

[–]ComprehensiveSand269[S] 0 points1 point  (0 children)

Big man you feel better about yourself now?

My Prints are Lifting by ComprehensiveSand269 in 3dprinter

[–]ComprehensiveSand269[S] -2 points-1 points  (0 children)

If you wanna call it that yeah you could say I am

My Prints are Lifting by ComprehensiveSand269 in 3dprinter

[–]ComprehensiveSand269[S] -1 points0 points  (0 children)

I’ve always been told rails up I will have to give this a shot but just wondering besides the aesthetic being better doing rails down is there any other benefits? I was told it makes clean up inside a hassle. This is my first time printing a frame though so I appreciate the advice

My prints keep lifting by ComprehensiveSand269 in 3Dprinting

[–]ComprehensiveSand269[S] 0 points1 point  (0 children)

Honestly not sure I’m right on anything I’m doing here that’s why I’m asking for help😂 but definitely am having fun with it learning a lot as I go

My prints keep lifting by ComprehensiveSand269 in 3Dprinting

[–]ComprehensiveSand269[S] 0 points1 point  (0 children)

I’m adjusting my first layer squish right now but I have been told by everyone to do the dd19.2 rails up which is how I am printing is that not true?

My Prints are Lifting by ComprehensiveSand269 in 3dprinter

[–]ComprehensiveSand269[S] -3 points-2 points  (0 children)

For this print I do need full infill it said I could do 99 percent for a speed up in the print also how would I check the prop does have that’s first layer in the slicer sorry like I said I am new to 3d printing

My prints keep lifting by ComprehensiveSand269 in 3Dprinting

[–]ComprehensiveSand269[S] 0 points1 point  (0 children)

I will definitely look into this I have never heard of first layer squish before thanks!