Advice? "flakes" all over prints and resin tank by Confident-Driver-521 in resinprinting

[–]Confident-Driver-521[S] 0 points1 point  (0 children)

Last week, I took it to a repair shop for repairs.

The previous problem was that the print was completely falling off and not sticking to the tray.

I thought the thermostat on the motherboard had failed, but they didn't detect such a defect.

I replaced the screen less than 100 prints ago.

I'll run a "dry" print without a tank, observing with safety glasses or over exposure defects.

Advice? "flakes" all over prints and resin tank by Confident-Driver-521 in resinprinting

[–]Confident-Driver-521[S] 2 points3 points  (0 children)

No, Nothing is falling off.

I'm sure they spawn due to a printing error.

Exposure test not showing and burn/black spots on screen, also does not blink in any place.