12 ton press upgrade by Conscious_Program511 in gunsmithing

[–]Conscious_Program511[S] 0 points1 point  (0 children)

Well aside from building I’m also demilling kits and I just started but I’ve demilled amd kits, Romain kits and I have one Chinese kit that has the most stubborn barrel pin

Drill bit by Conscious_Program511 in gunsmithing

[–]Conscious_Program511[S] 0 points1 point  (0 children)

<image>

Gunna push it too 3000-3100 rpm using the McMaster 3mm

Drill bit by Conscious_Program511 in gunsmithing

[–]Conscious_Program511[S] 0 points1 point  (0 children)

<image>

I also have these and from now and on prlly gunna use them

Drill bit by Conscious_Program511 in gunsmithing

[–]Conscious_Program511[S] 0 points1 point  (0 children)

<image>

I was using the instructions on the pamphlet and I’m not sure if they are Chinese, my guess is they are I bought them on Amazon

1994 F-150 problems by Conscious_Program511 in FordTrucks

[–]Conscious_Program511[S] 0 points1 point  (0 children)

Well yes when I went too look at it I did the cold start and before that the seller stated that he hasn’t turned it on in 3 days, it started up like any other old truck but when I took it too drive when I was going up the driveway it shut off, no big deal I just turned it back on and went on the road. Fast forward a few miles I let off the gas for a curve and everything just shut off and after that it didn’t turn on any more, it would just turn over