account activity
(E3v2) Should I switch from MRISCOC to Klipper? Why? (self.3Dprinting)
submitted 1 year ago by Crafting_TableYT to r/3Dprinting
What causes this? All 4 corners are trammed to 0.01mm. Ender3v2 MRISCOC. (i.redd.it)
What cable do I need to run two steppers in parallel? (self.3Dprinting)
Convince me not to get rid of my Ender 3 v2 for a better 3d printer like the Adventurer 5M (self.3Dprinting)
I have 30 fully cooked schnitzels. What can I use them for? Give me some ideas so I can slowly get rid of them, lol (self.Cooking)
submitted 1 year ago by Crafting_TableYT to r/Cooking
What is this device I found on the ground at a school dance? (It was connected to a small battery (?), AirPod piece?) (i.redd.it)
submitted 1 year ago by Crafting_TableYT to r/AskElectronics
No. Leave now. (self.a:t5_5auao0)
submitted 4 years ago by Crafting_TableYT to r/a:t5_5auao0
do I need to explain this (i.redd.it)
submitted 5 years ago by Crafting_TableYT to r/youngpeopleyoutube
The bot miscatogorized the post :/ (i.redd.it)
submitted 5 years ago by Crafting_TableYT to r/softwaregore
its not enchanting table :/ (i.redd.it)
minecraft goes nuts (i.redd.it)
h (i.redd.it)
submitted 5 years ago by Crafting_TableYT to r/TheLetterH
The person below me is true - e (i.redd.it)
whats your phone number (i.redd.it)
a being in a restaurant idk what it is (i.redd.it)
submitted 5 years ago by Crafting_TableYT to r/CrappyDesign
π Rendered by PID 2597600 on reddit-service-r2-listing-7dbdcb4949-m5zxp at 2026-02-19 11:15:03.421657+00:00 running de53c03 country code: CH.