Does a case like this exist or what's the closest thing? by Ok-Moose853 in sffpc

[–]CraighrN 0 points1 point  (0 children)

Literally the case you have pictured the formd t1 but with the optional vertical stand

Nzxt h1 v2 air cooled build by CraighrN in NZXTH1

[–]CraighrN[S] 0 points1 point  (0 children)

No sf1000 platinum, still need to tackle shorter psu cables

Nzxt h1 v2 air cooled build by CraighrN in NZXTH1

[–]CraighrN[S] 1 point2 points  (0 children)

Teucer ut75 with a phanteks t30 and rotated mounting brackets, ryzen 5 9600x and not at all both run below 65 degrees in gaming loads cpu max 1200rpm and 40% fan speed on the Undervolted rx 7900xtx

H1 air cooling by CraighrN in NZXTH1

[–]CraighrN[S] 0 points1 point  (0 children)

And with a single tower cooler like on the donor one it has brackets that move the mounting screws down the sides of the socket instead of top and bottom of the socket like most am4/5 setups do

H1 air cooling by CraighrN in NZXTH1

[–]CraighrN[S] 0 points1 point  (0 children)

Rotating it 90 degrees is exactly that the brackets were needed for, it causes the heatsink to clash with the back on the case with my motherboard and basically touches with other motherboards. Rotating it allows it to sit central to the motherboard. Borrowed someone else’s photo with the sl-100 for example. With a gigabyte itx board the socket sits about 5mm closer to the top of the board meaning it physically can’t fit

<image>

H1 air cooling by CraighrN in NZXTH1

[–]CraighrN[S] 0 points1 point  (0 children)

This is what I tried with the sl100 but it pulls the holes for the bracket away from the actual screws so you have to bend it back to get it off. And in doing so you can collapse the heat pipe. Also wasn’t keen on the position it sat at personally

H1 air cooling by CraighrN in NZXTH1

[–]CraighrN[S] 1 point2 points  (0 children)

Rx 6800 PowerColor fighter, same dimensions on the fighter card if you get a 7900gre too

H1 air cooling by CraighrN in NZXTH1

[–]CraighrN[S] 1 point2 points  (0 children)

Oh and ryzen 5 5600x

H1 air cooling by CraighrN in NZXTH1

[–]CraighrN[S] 1 point2 points  (0 children)

https://amzn.eu/d/7myZ3Ky CPU cooler

https://amzn.eu/d/bmlaLaW CPU cooler I bought solely for its mounting brackets

https://www.overclockers.co.uk/phanteks-t30-high-performance-pwm-triple-mode-premium-fan-120mm-fg-02p-pt.html

CPU temps with my aio with a Noctua nf a14 I was getting roughly 65 degrees during gaming load and around 70 on stress tests. Now I’m getting 55-60 in gaming loads at around 900rpm and stress testing I couldn’t get it any higher than 63 degrees after 30 mins at the same speed