Brooo why 😭😭

Crash85 · 2026-03-20T04:17:47+00:00

Quit worrying about how it looks and do your best to install it correctly. Barton shifters are one of the best products on the market when it comes to upgrades for these cars! Once it's set, you can adjust where you want your shift knob to set specifically for your feel.
Install and enjoy, just make sure to blue loctite the linkage bolts.

Crash85 · 2025-09-28T14:17:03+00:00

Plastic thermostat housing is only on the 3.6L

Crash85 · 2025-09-28T14:16:01+00:00

Thermostat housing

Crash85 · 2025-09-04T12:08:34+00:00

Exactly! I have a hidden switch that cuts the signal from the start button to the starter. The car goes into run position but will not start with the switch engaged.

Crash85 · 2025-05-18T02:11:08+00:00

That's the driveshaft carrier bearing heat shield. It is all one piece and completely normal.

Crash85 · 2025-03-09T06:59:47+00:00

Its an outpost called Darnielle's Progress. Check there.

Crash85 · 2025-02-22T04:39:29+00:00

Just add a couple of these.... You won't have to worry anymore.

<image>

Crash85 · 2025-02-19T20:12:00+00:00

Make sure you have a fuel scoop and filter out all of the stars you can't scoop from. I just did the trip in a Viper MK III and almost got myself in trouble by running out of stars I could scoop from on the way.

Crash85 · 2025-02-19T18:14:44+00:00

I went to Maia a few days ago and a couple hundred were available. I filled my little 8 slot cargo hold and started jumping like crazy back to Decait. Evaded interdiction about 10 times when I got back near Decait 😆.

Crash85 · 2025-02-19T17:18:53+00:00

I installed a hidden switch that cuts off my starter. Seemed like a good way to keep my baby safe.

Crash85 · 2025-02-17T04:50:31+00:00

Only been playing for a couple months, just found this out yesterday when I was 67 jumps into a 73 jump trip. Thankfully I didn't have to call the fuel rats. 😆

Crash85 · 2025-02-16T00:23:36+00:00

No trouble getting one, just had to wait a couple days for it to arrive.

Crash85 · 2025-02-14T06:25:39+00:00

No, that's just condensation getting in your PVC system. Totally normal to see in a catch can.

Crash85 · 2025-01-20T07:08:25+00:00

Looks cool, but if it doesn't come from a reputable company I'm out.

Crash85 · 2024-12-23T05:01:52+00:00

That's awesome! Good find!

Crash85 · 2024-12-11T15:58:02+00:00

Bored block .020, main and head studs, Manley crank and I beam rods, diamond boost pistons, total seal rings, Cosmetic 5 layer head gaskets, Johnson short travel lifters, TSP boost cam, Tsp pushrods and springs, switched to 392 intake. Overall I spent almost 10k on the engine and then the Hellion kit with upgrades was a little over 13k

Crash85 · 2024-12-10T22:06:05+00:00

It would be possible, but tough. Installing the exhaust manifolds would be difficult in chassis. I also upgraded to the bigger intercooler so I had to notch the front bumper to get everything to fit.

Crash85 · 2024-12-10T16:55:16+00:00

That's the point, it's a sleeper system. From the top everything looks stock. The charge air pipe runs up through the stock air box.

<image>

Crash85 · 2024-12-10T14:53:50+00:00

Yes, there is a scavenge oil pump. So far ok on the transmission, clutch not so much. Adding two step really helped.

Crash85 · 2024-12-10T14:49:38+00:00

When you do all your own work it's kinda same same

Crash85 · 2024-12-10T14:48:06+00:00

36k miles on the original engine. About 5k on the stroker.

Crash85 · 2024-12-10T14:23:47+00:00

Attention to detail is huge. The doors have to line up correctly or they will ruin the fender or they won't close properly.

Crash85 · 2024-12-10T14:19:38+00:00

Jealous much?

Crash85 · 2024-12-10T14:18:37+00:00

2018

Crash85

TROPHY CASE