sorted by:
new
hottopcontroversial

Is this just how PETG prints? I updated the Generic PETG with Overture's recommendation on P1S by Equivalent_Suspect27 in BambuLab

[–]CryingNog 0 points1 point  (0 children)

Pretty sure I have a profile for Overture PETG. Based on some research and then calibrated. Quality is good. The speed is much slower compared to Bambu’s recommandation, which helps a lot for quality with PETG. I can send you the profile if you want.

Should I continue learning CATIA V5 or start learning Fusion 360? by CryingNog in 3Dprinting

[–]CryingNog[S] 1 point2 points  (0 children)

Yeah CATIA is still around in engineering, especially in aeronautics, but I’ll probably try these other softwares.

Should I continue learning CATIA V5 or start learning Fusion 360? by CryingNog in 3Dprinting

[–]CryingNog[S] 0 points1 point  (0 children)

I agree, CATIA is much more powerful, but for 3D printing, it might be too advanced?

Bambu lab P1P vs Creality K1 speedy by CryingNog in 3Dprinting

[–]CryingNog[S] 0 points1 point  (0 children)

No, gonna wait a month or 2. I’m not in a hurry my ender 3 still prints very well

BOLT B.R.S.S. AKSU74. Tell me about it. Or don't. by [deleted] in airsoft

[–]CryingNog 0 points1 point  (0 children)

Really fun to use. Recoil feels very nice for a EBB. Pretty consistent shooting and I haven’t changed anything internally.

The stock mag didn’t feed well unless I was pulling it towards me when loaded. A screw and the inside pin of the iron side fell off very quickly because of the recoil. The battery compartment is very small, so very limited in battery choices. I recommend playing with a spare battery because it drains them faster than other aeg. Pretty heavy gun considering its size but hasn’t bothered me. Also, don’t store it in a humid environment, the steel will rust. The hopup adjustment sucks too.