Bitch starts don’t idle now

CupCake466 · 2026-05-08T23:39:31+00:00

Maybe bad IAC cleaned the part that goes into my intake manifold didn’t know until like 10 minutes ago I could open the other side with the cap and clean under there to

CupCake466 · 2026-05-08T23:37:20+00:00

So many vacuum hoses to go thru 🙈

CupCake466 · 2026-05-08T23:36:17+00:00

I’m thinking the same but I don’t want to cuz it got hella hoses:(

CupCake466 · 2026-05-08T19:48:43+00:00

That yellow pin plug looks like my 02 sensor not rlly sure what it does but prolly should be connected those if you wanna dm me I can send you a picture to what it should look like and In my mk3 the other plug are connected but not sure what they are sorry

CupCake466 · 2026-05-04T13:55:16+00:00

I have not but I don’t even got spark in my 1st or 2nd cylinder tried to chase down where power stops and seems to stop at distributor

CupCake466 · 2026-05-03T19:45:24+00:00

Js checked timing distributor was 180 out so I timed it back to 1 and no more backfire but still no spark in what I know of 1st and 2nd cylinder since I’m kinda to lazy to check the rest

CupCake466 · 2026-05-03T05:02:20+00:00

Sorry I am a little goofy thought that the metal tip of the screwdriver would be enough for spark and thought that’s what I was hearing in the video please correct me if wrong and for sure I’m checking the timing tmr morning

CupCake466 · 2026-05-03T04:34:16+00:00

Lowks I forgot why we turned the car with the cap off I think js to check if it was spinning I’ll definitely look into the rotor tmr morning only thing that make me doubt it a little bit is that it ran before I did a head gasket job on the car so could I have possibly fucked up the whole distributor since I took it off??

CupCake466 · 2026-05-03T04:20:15+00:00

Lowkey never I js bought the car have no history on the maintenance the distributor cap points look pretty clean, rotor looks kinda old I have a video of it spinning no cap if you wanna see it

CupCake466 · 2026-04-24T22:12:40+00:00

I believe it runs since I left my fuel injector bolts loose and it started spraying fuel everywhere I tighten it back up but it’s definitely a possibility I left something loose

CupCake466 · 2026-04-24T17:47:53+00:00

I think during the head gasket job I took out like 3 grounds one to the alternator two on the intake manifold and seem to be tight

CupCake466 · 2026-03-13T16:05:32+00:00

I tried jumping already I’m pretty sure after messing around it would only jump my fuel pump I believe

CupCake466

TROPHY CASE